Get matched with top pool and spa technicians in Altadena, CA

Yes, hot tubs can use a significant amount of electricity, primarily to keep the water heated. A typical hot tub uses between 1,500 and 6,000 watts, and the pump can add another 1,500 watts. This usage can result in a monthly cost of around $20 to $30. The exact amount of electricity consumed depends on several factors, including the hot tub's age, size, heater voltage (120V vs. 240V), usage habits, and thermostat setting. Newer, energy-efficient models generally use less power than older ones. To reduce electricity costs, consider investing in an energy-efficient model, using a quality insulated cover with a thermal blanket, and keeping the filters clean.

Follow these general safety tips for spas and hot tubs:

• Keep your exterior electrical receptacles covered and dry, especially around your hot tub and pool during periods of use.

• Make sure you have a GFCI (ground fault circuit interrupter) properly installed to ensure no one gets accidentally shocked or injured by electrocution. 

• Don’t use the hot tub or your pool during a thunderstorm. 

• Before using the hot tub, have a certified electrician thoroughly inspect your hot tub and its wiring to make sure you’re in full compliance with all applicable local building codes. 

For a fully-foamed hot tub, freezing typically occurs when the temperature drops below 28 degrees Fahrenheit and remains at or below this level continuously for a minimum of 36 hours. If your hot tub and pumps are still operational, however, the water circulates, and this continuous movement helps prevent freezing, even in very cold conditions. This circulation, along with the insulation provided by the foam, helps maintain the water temperature and prevent it from freezing during extended cold periods. Still, if you’re not planning to run it regularly, be sure to winterize the hot tub properly to prevent damage from freezing.

If water is left inside the hot tub pump over a cold winter, it could freeze and severely damage the pump, water lines, and jets. That can cause leaks, which require very expensive repairs. Freezing or leftover water can stain and damage the hot tub shell, which leads to replacement. Even in mild climates, leaving sitting water in the tub or pipes for a long period of unuse is a bad idea, since disinfecting chemicals fade and the water can develop bacteria, algae, and other big headaches when it’s time to use the tub again.