Get matched with top bathtub restoration pros in Naco, AZ

Before you begin caulking a shower, you’ll need to use a utility knife or solvent to remove the old caulk and inspect the area for mold. If needed, take appropriate steps to get rid of the mold, then wipe everything down with dish soap and warm water before letting it dry completely. Finally, surround the caulking area with two strips of blue painter’s tape—one above the joint where you’re caulking and another below it.

Yes, you can absolutely remove rust from a bathtub drain, and doing so can improve the appearance of your tub. Combine three parts baking soda with one part vinegar and mix into a paste. Apply the paste over the drain and let it sit for about an hour before rinsing with cold water. Repeat the process if some rust stains remain. If the stains return, consider installing a water softener, as ongoing issues with bathtub drain rust usually indicate hard water.

The cost of installing a new bathtub is considerably more expensive than refinishing an existing one, so if you’re looking to upgrade your tub on a budget, you might be better off refinishing it for now. Additionally, if your tub has only minor damage, refinishing it will make it look new again without the extra demolition and time. 

Bathtub refinishing refers to the entire process of resurfacing a bathtub. Reglazing is one step in the bathtub refinishing process. To refinish a bathtub, a refinishing professional will clean the tub, protect the surrounding areas, remove the existing glaze, sand and prepare the surface, apply the new glaze coating, caulk the tub, and replace the fixtures.