Top-rated egress window pros.

Get matched with top egress window pros in Florence, AZ

Enter your zip and get matched with up to 5 pros

Need a pro for your egress window service project in Florence, AZ?

Select your specific project to find the pro for you.

Find Egress window pros in Florence

Avatar for Vista Windows LLC
Vista Windows LLC
3.6(
7
)
Egress Window - Install

Serving Florence, AZ and surrounding areas

In business since 2013

Free estimates

Credit card accepted

"I hired him in December but it took until February for him to get here to put it in.  The cost actually came in under the estimated cost.  The installation went poorly.  I told him that we needed a 36" door, thinking that's what my initial contractor put in.  He was able to make the door opening larger, without having to change much.  After putting the door in it looked good, except he had used another casement.  I told him that I would replace it on my own.  I'm now going to have to take down the casement again and adjust the drywall.  The new door leaked the first time we had snow.  This leakage stained the casement, but I think I will still going to be able to use it still."
Recommended by66%of homeowners
Egress Windows questions, answered by experts

Yes, you can install a bay window in an existing house. You’ll need to have a structural engineer draw up plans to add the necessary support to your exterior load-bearing walls and a general contractor to make the changes to the framing around the new wall opening. This will cost an average of $3,000. After that work is done, a window installer can set the new bay window in place.

An egress window is similar to a regular window. However, this type of window opens fully to allow people to escape the home or rescue personnel to enter the home if an emergency occurs. Egress windows are required in all finished basements before they can be considered a living space.

You install a window well 8 to 12 inches deeper than the base of the window sill. After filling the well with drainage rock, the well should sit 3 inches below the bottom of the window. The top of the window well should also be at least 3 inches higher than the surface-grade ground. The window well should be about 6 inches wider than the window opening.

The proper way to install a window well is to measure the window, dig a hole deeper and wider than the window, place a drainage tube and cap, anchor the well to the foundation, caulk the seam, and backfill the hole. The job requires tools such as a hammer drill and auger and some heavy digging. Proper placement and window well installation are critical to preventing water from leaking into the window.

When you need new windows depends on a variety of factors, including the age of your windows, the age of your home, and the climate you live in. If you’re dealing with budget constraints, you don’t need to replace all your windows simultaneously. 

When buying new windows, you should consider energy efficiency, safety, and aesthetics to choose the right window for you.

The Florence, AZ homeowners’ guide to egress window services

From average costs to expert advice, get all the answers you need to get your job done.