Get matched with top deck maintenance specialists in White Hall, AR

Decks are generally more expensive to build because they require elevating and railings. The difference between decks and patios is that decks are elevated, while patios are usually on the ground level. Plus, decks are usually made of wood and need more maintenance than most patios. However, decks and patios serve the same purpose, providing outdoor space for you to enjoy.

Cutting the boards directly is one of the fastest ways to remove deck boards with hidden fasteners. Mark two parallel lines that are one-third of the total measurement on both ends and cut out the centerpiece. Then, remove the end of the board that doesn’t have a fastener. Finally, pry open the fastened side and pull it up to pop out the screw or access the fastener. This also allows you to salvage portions of boards for other projects.

Most building codes require that railing spindles (also known as balusters) on decks or stairs be spaced no more than four inches apart. This safety standard is often called the '4-inch sphere rule,' which means a sphere with a 4-inch diameter should not be able to pass through the opening between balusters. This rule is in place to prevent small children and pets from slipping through the railing. For the same reason, the space between the bottom rail and the deck or floor surface should also be no more than four inches. As a general guideline, professionals often install three balusters per foot of railing. However, since specific requirements can vary by location, it is essential to check your local building codes to ensure compliance before starting your project.

Be careful when choosing a product to help you remove ice from your wood deck. Never use sand, gravel, or salt, since these items can damage and scratch the wood. Instead, look for chemical de-icers that are marked as safe for wood decks or use hot water to melt snow and ice.