Best deck maintenance specialists near Sherwood, AR

Building a deck without a permit could lead to fines for both the homeowner and the contractor. The exact penalties will depend on your state and municipal building laws. You might also be required to remove the deck and apply for a permit before you can build another. While it might be tempting to skip the permit to save a few bucks, it’ll cost you much more if you’re caught.

Yes, pressure washing a wood deck can be a good idea as it effectively lifts ingrained dirt, mold, and mildew, improving the deck's appearance and longevity. However, it must be done carefully, as it's easy to damage the wood, especially softwoods. To pressure wash safely, use a lower pressure setting and a wide, 40-degree fan pattern nozzle (often white). Keep the nozzle at least a foot away from the wood surface and maintain constant motion, avoiding hovering in one spot to prevent gouging.

Before installing any materials under the deck for removing moisture, you should perform some prep work on the ground. Work the dirt under the deck to create a grade away from the home. A grade of at least six inches for every 10 feet works well. Do not leave a gap between the dirt and the home’s foundation where water could pool. Once you or a contractor regrades the dirt under the deck, you then can add materials over the top.

Most building codes require that railing spindles (also known as balusters) on decks or stairs be spaced no more than four inches apart. This safety standard is often called the '4-inch sphere rule,' which means a sphere with a 4-inch diameter should not be able to pass through the opening between balusters. This rule is in place to prevent small children and pets from slipping through the railing. For the same reason, the space between the bottom rail and the deck or floor surface should also be no more than four inches. As a general guideline, professionals often install three balusters per foot of railing. However, since specific requirements can vary by location, it is essential to check your local building codes to ensure compliance before starting your project.