Best countertop and backsplash pros near Lakeview, AR

The resin should be periodically sealed to help prevent it from wearing down or becoming porous. Very sharp or very hot objects can damage the resin surface, and there’s no way to fully repair it if that happens, so we recommend treating the counters well.

With proper care, Corian® countertops can last 20 to 30 years, and they typically come with a 10-year warranty. To maximize their longevity, it is important to fix any damage as soon as possible, clean up spills immediately, and address cosmetic issues promptly. Scratches, stains, and even burns can often be buffed out with sandpaper, and water stains can be treated with a specific water stain remover.

The angle at which you cut countertops depends on the material, your intended outcome, and the location of the cut. For example, rather than cutting a straight 90-degree angle for internal corners, cut edges at a 45-degree angle to give a clean, professional look. For outside edges, most homeowners want squared-off sides, so 90-degree angles can make the most sense there. Because you want to get angles exactly right to minimize seams and eliminate the need for patching, be sure to measure several times before cutting and use the right equipment to get sharp, accurate angles.

Yes, Corian® and other solid surface countertops can be cut with standard woodworking tools like a circular saw or a jigsaw, but using the correct blade is crucial for the best results.

The recommended blade is a tungsten carbide-tipped blade, often called a solid-surface planer or triple chip grind blade. This type of blade is hard enough to cut through the material effectively. For a jigsaw, a fine-tooth down-cutting blade should be used.

It is important to note that a diamond blade is not necessary. Diamond blades are designed for harder materials like natural stone, concrete, or brick, and Corian is not a natural stone.

Using blades designed for wood is not recommended as they can cause microfractures that weaken the countertop's edges. While a tungsten carbide blade provides a much cleaner cut, the resulting edge will still be rough and must be sanded and smoothed to prevent microfractures from developing over time.