Get matched with top door pros in Jasper, AR

You can’t gauge the lifetime of a fire door like you could, say, an engine. Fire doors should be checked at least once every six months to ensure there are no signs of degradation like leaks, holes, water damage, termite damage, or anything else that might compromise the functionality of the door’s fire resistance. Check your smoke detectors while you’re at it.

Most modern, standard doors are 1 ⅜-inches thick, so you should aim for this thickness unless you're building a door to replace an antique door or fit into a non-standard wall opening. Thickness varies when installing a pocket door or sliding barn door, so a good rule of thumb is to measure your existing door, if possible. For standard doors, you can also measure from the inside of the door to the door stop to gauge the proper thickness.

WD-40 can be used on squeaky door hinges, but it is generally considered a temporary, short-term solution rather than a long-term fix. While it can silence a squeak in a pinch by breaking down rust and grime, it is not a true lubricant, as it contains only a small amount of lubricating oil that evaporates quickly. Using WD-40 alone may lead to the squeak returning and can attract dirt and dust, potentially causing more wear on the hinge over time. For a more effective and lasting solution, it is recommended to first use WD-40 to clean the hinge, then wipe it clean. Afterward, apply a dedicated lubricant such as silicone spray, white lithium grease, a metal or plastic lubricant, or an oil-based product like petroleum jelly.

To build a standard size, six-panel door yourself, you’ll need four 2-foot by 6-foot boards, one 2-foot by 8-foot or 2-foot by 10-foot board, and a sheet of 3/4-inch, paint-grade plywood. The 2-foot by 6-foot boards will serve as your stiles, top rail, and horizontal and vertical mullions, and the wider board will serve as the bottom rail, which is usually wider than the other horizontal pieces. The plywood will serve as the panels, but you’ll need around five 1-foot by 6-foot boards to make your own panels if you want to stain the door rather than paint it.