Get matched with top appliance repair pros in Seward, AK

You might need to install a new outlet if there isn’t one already located within 5 feet of the hot tub or if the current outlet you have installed and plan to use with the hot tub isn’t sufficient to carry the required electrical load. Most current hot tub models use 50 to 60 amps and require 220 to 240 volts to function. The cost to install a 220 outlet averages about $220, according to HomeAdvisor. 

A washer and dryer must be plugged into a GFCI outlet when installed in a laundry room, utility room, garage, or basement with the required water source. These spaces require that all outlets be GFCI-protected. Elsewhere, there is no specific requirement for plugging a washer and dryer into a GFCI outlet. However, you may wish to do so for extra peace of mind.

While it’s possible to only replace an evaporator coil to keep your AC running, this could cause issues down the line. An AC system relies on the harmony between its condenser and evaporator coils for efficient operation. Replacing only one coil, especially in older units, can cause compatibility issues, leading to inefficiency and potential system breakdown. 

As AC units near the end of their expected lifespan, investing in the cost for a new AC system is typically better than paying for individual component upgrades to avoid costly repairs and ensure optimal performance.

You can convert a gas heater to electric, but it isn’t as simple as swapping a plug or two. First of all, you need to make sure there’s adequate power to the unit, as electric units require much higher power amounts versus gas. Then, you need to close off the gas lines and ventilation. Make sure you don’t also need a permit for an electric water heater—some cities require it. Making the switch can cost upwards of $1,500.