Get matched with top toilet pros in Williamstown, WV

There are several ways to save money on a bathroom remodel through proper planning and savvy design strategies. To reduce costs, consider the following:

• Purchase your own materials: Buy your own bathroom fixtures, hardware, and other materials to avoid contractor upcharges and delivery fees.

• Shop smart for big-ticket items: Save on pricey items like tiles and tubs by shopping sales and at discount stores.

• Avoid major layout changes: Keep plumbing in its current location. Opt to replace fixtures rather than moving them to avoid significant renovation work.

• Focus on high-impact, low-cost updates: Make affordable but impactful smaller changes, such as upgrading hardware, installing new lighting, and adding stylish but economical accessories.

• DIY where possible: Handle easier parts of the remodel yourself, like painting or installing light fixtures, to save on labor costs.

• Time your remodel strategically: Consider remodeling in the spring, which tends to be a lower-demand time of year and may result in lower costs.

Basement toilets don’t always need a pump. However, it is the most common setup because plumbing systems use gravity to move waste away from the home. Basement toilets often sit below the home’s main sewage system, and installing a sewage ejector pump pushes the wastewater and sewage up to the main sewer line. Alternatively, you can use an upflush or macerator toilet that breaks down the waste and pushes it straight to the main sewer line rather than via a sewer line from the bathroom.

While you shouldn’t increase the flow of your low-flow toilet by adjusting the water level in the toilet bowl set by the manufacturer, you can make the flow as efficient as possible by ensuring the rim jets under the rim are unobstructed. To do this, use a mirror to look under the rim and scrub them with a toothbrush or a small wire to clear any debris stuck in the holes. You can also watch for leaks, make sure the internal components are in good shape, and replace them if necessary.

Yes, you should screw your flange to the subfloor, including cement. The best way to get this done is to predrill holes into the concrete using a hammer drill and a ¼-inch concrete bit. Be careful when you’re ready to bolt your flange down, as you can accidentally crack it. You can avoid this issue by not installing the screws too deep. Or, you can opt for a flange with a stainless steel ring so you don’t have to worry about cracking the plastic.