Get matched with top siding pros in Mill Creek, WV

Steel and aluminum are two types of metal siding that are commonly used for residential and commercial buildings, but the materials have specific differences. Typically, steel is heavier and sturdier, fending off scratches and dents, while aluminum is lightweight and more prone to damage. Cost is another differentiating factor, as steel is more expensive than aluminum siding cost.

You should plan to stain or refinish your home's cedar siding every three to seven years to maintain its appearance and provide maximum protection, though some estimates suggest a range of four to six years. The exact frequency depends on several factors, including your local climate, exposure to severe weather like direct sunlight, rain, and wind, the quality of the initial stain application, the type of stain used, and the overall condition and quality of the wood.

For homes in harsh climates with high humidity and significant sun exposure, you should plan on staining as often as every three years, while those in milder locations may only need to do so every seven years. For the longest-lasting protection in particularly harsh climates, consider using an opaque stain.

If you are looking for a lower-maintenance alternative, you might consider vinyl or aluminum siding. While the initial installation cost can be higher, they do not require as much upkeep and can offer more value over time, especially in areas with excessive rainfall or high humidity.

Wood clapboard siding needs frequent sealing to keep it in top condition—likely every two to three years. A sealant helps protect it from both moisture and sunlight damage. Your weather and climate will affect how often you need to seal the siding, but the pros recommend sealing it every couple of years. More durable woods in milder climates may not need to be sealed quite as often.

To calculate how much siding you need for exterior walls, first measure the height and width of the rectangular walls. For the triangular gable walls, measure the width and then the height from the ground to the tallest gable point.

• For the rectangular walls, the calculation is: length x height

• For the triangular gable walls, the calculation is: (length x height) / 2

Once you add these up, include an additional 10% to account for any wastage.