Get matched with top drywall pros in Bruno, WV

The easiest way to cut holes in drywall for electrical boxes is to use a spiral saw with a drywall router bit. Hang the drywall without cutting out a hole for the box, but make sure you measure and mark where the box is located on the wall. Once you screw in the drywall sheet, drill a small hole into the box void, insert the spiral saw bit, and move it around the edge of the box using the inside wall as a guide. You can also use an oscillating multi-tool with an electrical box cutout for fast, professional results.

You can prevent air leaks and sagging by gluing a drywall ceiling. However, not every drywall job is a good fit for Sheetrock adhesive, and many pros say ceilings are one of those cases. When you place them properly, drywall screws make ceiling Sheetrock part of your home’s structural support system. 

Adding glue won’t increase the strength of the drywall, and it can make it much harder for you to remove and replace damaged drywall. Adhesive can bridge gaps, though, and it can keep temperature-controlled air from escaping or entering through the ceilings, making rooms more energy efficient.

Yes, as drywall mud is going to have some uneven spots and bumps after application. Such imperfections are going to be visible after everything dries and even after you paint the wall, so you want to remove them. Learning how to sand drywall, taking your time, and following drywall sanding tips can help you have the best results.

There are a few easy ways to locate a wall stud without a stud finder. First, try knocking on the wall with your knuckles. Most parts of the wall will sound hollow, but when you tap over a stud, it will sound more solid. Alternatively, since studs are spaced 16 or 24 inches apart, you can measure those distances from a corner of the room, which will always have a stud.