Get matched with top insulation pros in Suamico, WI

Yes, cold walls are a common indicator of poor or inadequate insulation, especially if the walls feel significantly colder than the air in the room. This suggests that heat from your furnace is escaping rather than being retained. The issue could be that the walls have no insulation, or that the existing insulation is old or has been damaged by water, moisture, or pests. Your best course of action is to hire a professional to investigate. An insulation contractor can determine if you need to add or replace insulation and can often perform the work without creating large holes in your drywall. If you suspect the problem might also be related to your heating system's performance, an HVAC technician can take a closer look.

To cover your HVAC ducts and air vents during construction, use plastic sheets or drop cloths secured with painter's tape. Be sure to cover all supply vents on your floors and walls, as well as the larger HVAC return vent, which is typically on the ceiling. While canvas drop cloths can also be used, they may not catch all the fine dust. It is crucial to shut off your HVAC system or at least the zone where construction is happening. Running the system with vents sealed can put significant strain on the blower motor and air handler. For additional dust containment, you can also hang plastic sheets over doorways to separate the construction area from the rest of your home.

Yes, even though frost-free and freeze-proof faucets are designed to withstand winter weather, it is still recommended to cover them with an insulated cap, especially during periods of extreme cold. These faucets work by keeping excess water inside the home's heated space and using a downward slope to drain, but this protection can be compromised. For the faucet to work correctly, you must always disconnect any attached hoses before temperatures drop below freezing, as a hose can trap water and lead to freezing. Ultimately, covering all outdoor faucets, even freeze-proof models, is the best way to prevent frozen and burst pipes.

You should not use spray foam insulation in several specific areas. Avoid applying it in spaces exposed to high temperatures, such as near electrical boxes or recessed lighting, unless the foam is specifically rated for such use. Applying foam near electrical boxes can damage the wiring, and using it too close to lightboxes or recessed lights creates a potential fire hazard. Additionally, do not use spray foam in areas prone to shifting or movement, as this can lead to cracks and gaps in the insulation. Finally, open-cell foam is unsuitable for use below ground or in areas exposed to moisture because it can absorb water, which compromises its insulating effectiveness.