Top-rated paving pros.

Get matched with top paving pros in Lodi, WI

Enter your zip and get matched with up to 5 pros

Need a pro for your paving service project in Lodi, WI?

Select your specific project to find the pro for you.

TRUSTED BY LODI, WI HOMEOWNERS

  • Average homeowner rating star icon4.4
    Average homeowner rating
  • Verified reviews icon37
    Verified paving services reviews

Find Paving pros in Lodi

Avatar for A+ Tree & Arborists LLC
A+ Tree & Arborists LLC
5.0(
1
)
Interlocking Pavers for Patios, Walks & Steps - Install

Serving Lodi, WI and surrounding areas

Approved

In business since 2001

"We have used A+ Lawn Care for a number of years. Was thrilled when they added the tree and arborist services. They showed up today to 'clean up' the sucker growth on 2 very large Honey Locust, a crab apple and a cluster of mulberry trees. As always the crew that showed up, were prepared to work, did their work, cleaned up after themselves. In this case, I reminded them we had concrete decorative curbing around 3 of the 4 trees. Installed by A+ Lawn Care but buried in the snow. They carefully cleaned the snow off the curbing so they knew where it was. No damage done. We weren't so lucky with another tree company - and there was no snow then. Our experience with A+ Lawn Care and now A+ Tree & Arborist were great. I have recommended A+ Lawn Care a number of times and will do the same for A+ Tree & Arborist"
Showing 1-10 of 46
Paving Services questions, answered by experts

The ideal distance between stepping stones depends on your design preference. A general rule is to place them about 24 inches apart from center to center to match an average person's stride. Another common approach is to leave about 6 inches of space between the edges of each stone; this can be adjusted to fit the path's total length without cutting pavers. If you plan to plant between the stones, leave at least 6 to 8 inches of space to give the plants room to grow.

Professionals restore the surface to a fresh, attractive finish by applying a new, even sealant layer.

While some areas may allow for a slope of up to 20%, this is often the maximum slope for driveways, with a few exceptions of up to 25%. Other regions may have a maximum of 12%, 15%, or 18%, so check with your local building department to ensure you’re laying a driveway that is up to code for your location.

The layer of polymeric sand under the pavers plus the polymeric sand that gets swept into the joints between your pavers holds them in place in a few ways. For one, the gritty texture of the sand helps lock the pavers together. Polymeric sand also contains bonding agents that get activated by water. Polymeric sand will take between 24 and 48 hours to fully cure, so do not walk on your paver walkway before this time.

Building a road on a slope requires careful planning and will normally require a drainage system underneath to prevent flooding and damage to the road over time. Your professional may lengthen your road to create switchbacks if the slope directly to your home is too steep, as there are regulations for maximum road slope. The drainage system will help prevent runoff from the higher side of the slope from damaging the asphalt or concrete. Keep in mind that building a road on a slope isn’t a good DIY project, as a lot can go wrong.

The Lodi, WI homeowners’ guide to paving services

From average costs to expert advice, get all the answers you need to get your job done.