Top-rated energy efficiency auditors.

Get matched with top energy efficiency auditors in Chetek, WI

Enter your zip and get matched with up to 5 pros

Need a pro for your energy efficiency auditing project in Chetek, WI?

Select your specific project to find the pro for you.

Find Energy efficiency auditors in Chetek

Avatar for Blue Hills Roofing & Construction LLC
Blue Hills Roofing & Construction LLC
4.0(
43
)
Energy Audit - For BusinessHome Energy Audit

Serving Chetek, WI and surrounding areas

In business since 2004

Credit card accepted

"They did a magnificent job of installation and the clean-up was perfect. They removed the old roof quickly, made sure the roof boards were in good shape and put the new roof on in a little over 1 day. They were careful around my plants. We even were able to get some money back for bad shingles that were used on our old roof and the best part was they did all the paperwork!! When they came over to bid the job they were very professional, had a folder with all the information put together with different roofs in the area we could look at before we made our final decision. I highly recommend them to anyone looking for a new roof!!
"
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+8

Recommended by85%of homeowners
Energy Efficiency Auditing questions, answered by experts

It’s not recommended to turn off your breaker box in hopes of saving electricity. Breaker boxes were not designed to constantly be switched on and off. Therefore, turning off breakers unnecessarily can cause costly damage that outnumbers any energy savings. Only flip your breakers if absolutely necessary when troubleshooting an electrical issue.

Homeowners may qualify for an HVAC tax credit if they install an ENERGY STAR®-certified HVAC system that exceeds the energy efficiency minimum standards:

  • Split-System AC: 16 SEER2

  • Packaged AC: 15.2 SEER2 and 11.5 EER2

  • Ducted Split Heat Pump: 15.2 SEER2, 7.8 HSPF2, and 11.7 EER2 

  • Packaged Heat Pump: 15.2 SEER2, 7.2 HSPF2, and 10.6 EER2

  • Mini-Split System: 16 SEER2, 9 HSPF2, and 12 EER2

You can claim up to 30% of the cost of the job, subject to maximums.

Motion-sensor lights use one watt while on standby and five watts while turned on. They’re usually on for one hour over a 24-hour period, bringing the total wattage to about 28 watts per day. LED lights use around 6.5 to 8 watts while on. If you leave an LED light on all night, with night ranging from 10 to 14 hours, you’re looking at using 65 to 112 watts a night. You can minimally cut your wattage in half by switching to a motion-sensor light.

Blower door tests are measured in a few different ways, but the most popular are air changes per hour (ACH) and cubic feet of air (CFM) moving through the house per hour. A good ACH score is less than 2ACH, but 1ACH is better. This means the house experiences a total air change within 60 minutes (for 1ACH). For 2ACH, there’s a complete change every 30 minutes, and so on. CFM scores are similar in that a lower score means less air change, and therefore less leakage.

If you want a new boiler that’s going to help lower your fuel bills, you should buy one that has a high energy-efficiency rating. For example, a boiler that is rated “A” uses at least 90% of the energy created by the boiler. And in order to enjoy the best performance, it’s important to have it installed properly by a highly-rated tech.

The Chetek, WI homeowners’ guide to energy efficiency auditing services

From average costs to expert advice, get all the answers you need to get your job done.