Get matched with top electricians in Birchwood, WI

The cost to install or replace a circuit breaker depends on the price of the unit itself and the complexity of the installation. A new circuit breaker typically costs between $10 and $100, with standard breakers being the most affordable and GFCI or AFCI types costing more. If you are upgrading to a higher amperage, a 200-amp circuit breaker can cost between $250 and $350. The average total cost for professional installation is around $700, but this price varies. A simple replacement into existing wiring will cost less than a more complex project that requires opening walls, running new wires, and securing permits.

Under-cabinet lighting is generally energy-efficient, especially when using LED technology. Compared to traditional ceiling lighting or older bulb types like halogen and incandescent, LED under-cabinet lights consume significantly less energy, which helps reduce operating costs. This applies to various forms, including strip lights, puck lights, and built-in fixtures. For an option that uses no electricity, consider battery-operated puck lights. While they require periodic battery replacements, they have the added advantage of functioning during a power outage.

According to the National Electrical Code (NEC), GFCI outlets should be installed in wet or damp locations where they might be splashed with water or other liquids. This is to protect against ground faults, which are more common around water. Specific areas that require GFCI outlets include kitchens (especially near counters), bathrooms, laundry rooms, basements, garages, and all outdoor receptacles. Depending on local electrical codes, you may need at least one GFCI outlet in these rooms, or every outlet in the area may need to be GFCI protected.

Yes, one wire is always hot on the 3-way switch, meaning it carries the electricity from the power source to the switch. If you have a 3-wire cable in your home, you have two hot wires, or line wires, coming from the power source. Typically, you’d connect the hot black wire from the power source to the traveler wire and the hot red wire from the power source to the first 3-way switch. For the second 3-way switch, you’d then connect the hot black traveler wire to the switch.