Get matched with top fencing pros in Republic, WA

While they can be closer, the maximum distance between fence posts for residential fences is 8 feet. This ensures the panels are adequately supported by the fence posts. This is usually dictated by the width of the panel, which is typically between 5 and 8 feet. While narrower panels will require more posts, they’ll be lighter and easier to work with than wider panels that are the same height.

Knowing how close to the property line you can build a fence is an important planning step in your fence installation project. In many U.S. states, you are allowed to build a fence directly on the property line as long as your neighbor signs off on the plan. But check with your state government because some states and municipalities require a couple of inches before your property line.

You can DIY a stockade fence installation, but prepare to put in some good sweat equity. For the best results, carefully plan the exact location of your fence before you break ground. In particular, carefully map out your post locations before setting them in concrete. Be sure to call your local utility company before digging to avoid damaging underground wiring and causing severe injury.

On the other hand, installing stockade fencing on your own might sound too overwhelming. It’s certainly time-consuming and labor-intensive. Besides the hard work, you must install it properly to avoid gaps. Unless you’re confident you can get the job done right, hiring a privacy fence installer near you is the way to go.

You can sometimes install a fence over a gas line. Fence installation typically requires a two-foot depth for posts, so if the lines are shallower than two feet, you cannot put a fence post over the line. You’ll need to call 811 to get the gas lines located and marked before you start the project.