Get matched with top roofers in Rocky Mount, VA

Unfortunately, there’s no definitive answer to this question, but the wind rating of your shingles will give you a good idea of what wind speeds can damage your roof. If you’re concerned about damage, inspect your roof following windy conditions to look for signs of wind damage to your shingles. When in doubt, consider hiring a professional who fixes roofs to carry out an expert inspection. Remember that hurricanes, tropical storms, and tornadoes are likely to cause the most damage, but even severe thunderstorms can bring winds that compromise your roofing system.

Yes, gable vents can let water in. That being said, this usually only occurs during extreme conditions like heavy rainfall. You can prevent water from entering through gable vents by adding a screen that traps the water before it can enter.

No, there’s no specific building code that requires a roof overhang. However, installing your roof with the standard 2-inch overhang is good practice, as it helps direct runoff away from your fascia boards and roof decking and into your gutters. Some overhang is especially important in areas that see heavy rainfall and snowfall, as the risk of water getting under the roofing material and causing water damage is much higher.

The proper specifications for furring strips can vary, so you should always consult the roofing manufacturer's guidelines or your roofer. However, general recommendations are as follows:

• Thickness: Furring strips are typically 1 to 1-1/2 inches thick, meaning standard 1-by or 2-by lumber works well. In areas with extreme winds, a thinner strip may be preferred to limit how much air can get under the roof and cause uplift. A thicker strip can add slightly more insulation but will also increase installation costs.

• Spacing: The recommended spacing for furring strips is between 12 and 24 inches apart on center. Proper spacing is crucial for ensuring good airflow, adequate drainage, noise reduction, and better energy efficiency. The ideal spacing can depend on the roof's pitch and the specific type of metal roofing being installed.