Get matched with top driveway sealcoating pros in Uintah, UT

The best time to seal a driveway is during periods of mild, dry weather, typically from late spring through early fall. For the sealant to bond and cure properly, it needs warm conditions. Avoid sealing in the winter when temperatures are too low.

For optimal results, follow these guidelines:

• Temperature: Apply sealant when air and surface temperatures are consistently above a minimum of 50-55°F. The ideal range is often between 60°F and 80°F. Avoid applying sealer in extreme heat (above 90-95°F), as it can cause the sealant to dry too quickly and improperly.

• Weather: Choose a time with no rain in the forecast for at least 24 to 48 hours after application. Rain can wash away the sealant before it has fully cured.

• Timing and Cost: While spring and fall offer ideal temperatures, they are also the busiest seasons for driveway sealing companies, which may lead to higher costs due to increased demand. The best specific month will depend on your local climate.

When comparing installation costs, asphalt is often less expensive upfront than concrete. Asphalt prices typically range from $7 to $15 per square foot, while concrete can range from $3 to $18 per square foot. However, long-term costs should also be considered. Concrete driveways generally last longer (up to twice as long) and require less maintenance, which can make them more affordable over their lifespan. While asphalt has a lower installation cost and is easier to repair, it requires more frequent maintenance, such as sealing, which can add up over time. Therefore, while concrete is more expensive initially, its durability may offset the cost in the long run.

If your asphalt driveway shows cracks, potholes, or standing water, it’s likely time for a repair. Cracks, big or small, let water seep in, weakening the base and causing further damage. Potholes are a sign of this weakening process in action while standing water suggests your driveway has poor drainage, which can cause even more issues. You may also see warping or buckling—a sign of a compromised base layer—or sinking pavement. Spotting these signs early on can help you save yourself a bigger repair bill in the future.

You should always power wash your driveway before applying a sealant. At any given time, your driveway could be covered with algae and moss, tire residue, oil and rust stains, and any combination of leaves, twigs, and dirt. If you skip power washing, you’ll be trapping the dirt and grime beneath the sealant and lowering its chance of cementing itself to your driveway. While you can expect the cost to pressure wash your driveway to average between $100 and $350, the few hundred dollars beats an unattractive driveway or paying extra to reapply your driveway sealer.