Get matched with top driveway sealcoating pros in Hooper, UT

When hiring an asphalt paving contractor to install your driveway, ask as many questions up front as possible. Here are a few questions to ask a prospective driveway contractor:

• How many years of experience do you have?

• Are you licensed, bonded, and insured?

• Do you have worker’s compensation?

• Do you use subcontractors on your projects?

• Do you clean up after the job is done?

• Who is responsible for any damage to lawn or landscaping?

• Do you provide a guarantee or warranty on your work?

• Do you give free estimates?

• What is the timeline for completion?

• How do you handle change orders?

• Can you provide at least three references?

• Can I see some of the work you’ve done?

You should always power wash your driveway before applying a sealant. At any given time, your driveway could be covered with algae and moss, tire residue, oil and rust stains, and any combination of leaves, twigs, and dirt. If you skip power washing, you’ll be trapping the dirt and grime beneath the sealant and lowering its chance of cementing itself to your driveway. While you can expect the cost to pressure wash your driveway to average between $100 and $350, the few hundred dollars beats an unattractive driveway or paying extra to reapply your driveway sealer.

Chip seal lasts only 5 to 8 years on average. This lifespan is significantly shorter than asphalt. It is also less durable. Therefore, chip seal driveway only works if the traffic volume is extremely low. Chip seal is also less resistant to storms and hails. As impact builds up, the chips may become misplaced, creating an uneven driving surface that sometimes becomes hazardous and may damage your tires or cause your vehicle to lose balance.

No. You cannot use asphalt products on concrete driveways. To seal a concrete driveway, use acrylic, epoxy, polyurethane, silane, siloxane, and silicate sealers or deep penetration sealers made specifically for concrete. Meanwhile, asphalt sealers contain refined coal tar (asphalt emulsion), water, sand, clay, polymers, and additives and are incompatible with concrete’s surface texture and higher density.