Get matched with top dishwasher installation pros in Riverton, UT

To clean an old dishwasher without a filter, start by removing the bottom rack to access the drain area. Use a damp cloth or sponge to wipe down the interior, paying special attention to the corners and crevices where food particles and debris can build up. Pour a cup of white vinegar into a dishwasher-safe bowl and place it on the top rack, then run a hot water cycle to help break down grease and grime. After the cycle, sprinkle a cup of baking soda across the bottom of the dishwasher and run a short hot water cycle to deodorize and further clean the interior. 

Yes, a dishwasher needs an air gap to prevent backflow. Additionally, in many locations, air gaps or another measure to prevent backflow are required for building code compliance. There are alternatives to an air gap, like a Studor vent or a loop and trap design, but an air gap is the simplest and most popular solution.  

If the dishwasher is in working condition, start and run a complete cycle with nothing inside. Let it drain and sit overnight before removing the hoses. In theory, it should effectively drain. You may find residual water in the hoses, but you can plug them. If the dishwasher breaks down midcycle it can sometimes be full of water. You’ll need to manually remove the water with a plastic cup before removing the dishwasher.

Some signs that your dishwasher is going out include:

• The door no longer latches 

• Dishes are still dirty after a cycle 

• Dishes are cold after a cycle 

• Rust inside or outside the unit 

• Cracks inside the dishwasher tub

• Water collecting at the bottom or outside the unit

If your dishwasher is not energy-efficient or is older than 10 years, you should also consider replacing it. Repairing an older model may be more expensive than replacing it with something newer and more energy- or water-efficient.