Get matched with top dishwasher installation pros in Lindon, UT

Water is sitting at the bottom of your dishwasher, likely because the filter is dirty with food debris or because the drain hose has a clog. If the water is still sticking around after following the steps above, it’s time to contact a local plumber.

Depending on your available time and skillset, there are some aspects of dishwasher repair you can DIY. Remember that dishwashers use water and electricity, which can cause potentially hazardous situations. However, there are some things you can do to reduce your overall repair cost, such as:

• Cleaning the spray arm

• Unclogging the float

• Replacing the door gasket

• Cleaning the door filter

• Adjusting the door latch

To get rid of standing water in your dishwasher, first try activating the drain mechanism by pressing and holding the cancel button for at least three seconds. If that doesn’t work, you’ll need to do some troubleshooting to drain the standing water from the dishwasher. This will involve shutting off the power, then scooping out the water, cleaning the drain filter, and clearing the air gap. You’ll also want to run the garbage disposal and check the drain hose for clogs.

When a dishwasher discharges its wastewater, it uses a pump to quickly move a lot of water. If anything in the drain line or the garbage disposal impedes the high volume of water, it will back up into the sink through the drain or the garbage disposal. Following regular dishwasher maintenance tips like clearing clogs, keeping them cleared, and occasionally running the disposal will eliminate the problem.