Get matched with top affordable plumbers in Penrose, UT

Signs that your shower valve has gone bad include a variety of issues with water flow and temperature. Common symptoms are low water pressure, inconsistent water temperature, and dripping or leaking from the handle or showerhead when the water is off. You might also notice that the knob is difficult to turn or won't turn at all. Another key indicator of a bad diverter valve is water coming from both the tub spout and the showerhead simultaneously, or being unable to switch the water flow between the two fixtures. In advanced cases, the water may not turn on at all. These are all signs that the valve may need to be replaced.

Whether an earthquake gas shut-off valve is required depends on your location and circumstances. Certain cities, states, and even insurance providers mandate them, especially in areas with high seismic activity. In California, for example, while laws vary by county, most jurisdictions require a valve to be installed in newly constructed homes or when a home is sold or renovated. The Los Angeles Municipal Code specifically requires a licensed contractor for installation. Even if not required by law, installing a seismic shut-off valve is a wise safety measure. These devices automatically cut off the flow of gas during an earthquake, which can prevent gas leaks, fires, and explosions. It is recommended to check with your local building department for specific laws regarding installation, permitting, and inspections, and to ensure the valve you install is on your city's list of approved models.

Older faucet fixtures may have some corrosion, leaving them stuck. Try a few techniques to loosen the fixtures.

• Wrap the fixture with a towel and tap the base with a hammer.

• Use a putty knife to gently remove any caulk that may be holding the handle or fixture in place.

• Apply a few drops of penetrating oil around the base of the fixture or around the nuts.

• Purchase a faucet pulling tool to pop the fixture loose.

Sometimes when a pipe bursts in a house, it makes a clang or popping noise; however, that doesn’t mean you’ll hear it. Newer pipes tend to be quieter than older pipes. Plus, a pipe can easily burst out of earshot, especially if it’s a floor or two away from you. 

If you do hear an unusual popping noise, consider hiring a plumber to inspect your pipes. Most of the time, you’re more likely to notice a burst pipe either from a visible leak or because water won’t run out of your tap properly.