Top-rated electricians.

Get matched with top electricians in Beaver, UT

Enter your zip and get matched with up to 5 pros

Need a pro for your electrical service project in Beaver, UT?

Select your specific project to find the pro for you.

Find Electricians in Beaver

Avatar for D&D Electric LLP - Home  Facebook
D&D Electric LLP - Home Facebook
4.5(
6
)
Ceiling Fan - InstallCeiling Fan - RepairElectric Vehicle Charging Station Installation - For Business - Materials Provided by Consumer+15 more

Serving Beaver, UT and surrounding areas

In business since 2006

Free estimates

Credit card accepted

"they were very prompt, service was great. they check the outside breaker box then called power co. the problem was a power surge due to power co. d&d electric recommended a surge protection which i had installed. i had called two other electric co. and didn't get a call back."
Response time3 days
Recommended by80%of homeowners
Showing 1-10 of 28
Electrical questions, answered by experts

You can check if an electrician is licensed in California by using the online check a license tool offered by the Department of Consumer Affairs Contractors State License Board. You have the option of searching by the license number, the electrical contractor’s name, or the name of the business to determine the electrician’s status.

Usually, your house panel is one of the key components that must be replaced when upgrading your amp service. In many cases, you will also need to upgrade your meter base as well as other electrical components.

Regular inspections, avoiding circuit overloads, and updating wiring when needed help maintain efficiency.

Several signs can indicate a light switch is bad. If the switch feels loose, slides down after you flip it, or requires multiple flicks to turn the light on, it may be failing. Other common indicators include flickering lights or a general failure to turn the light on or off. Pay attention to any unusual sounds, such as crackling, buzzing, or popping when you operate the switch. More serious signs, which can present a fire or shock hazard, include the switch feeling excessively warm or hot, sparking, smoking, or emitting a burning smell. If you notice any of these dangerous signs, stop using the switch immediately and call an electrician.

The National Electrical Codebook indicates that there should be at least 6 inches of wiring in the breaker box for connecting purposes. When in doubt, err on the side more, because you can always cut some wire off but you can never add it back on, and if you don’t have enough you may struggle to finish wiring your breaker box properly.

The Beaver, UT homeowners’ guide to electrical services

From average costs to expert advice, get all the answers you need to get your job done.