Top-rated electricians.

Get matched with top electricians in Aurora, UT

Enter your zip and get matched with up to 5 pros

Need a pro for your electrical service project in Aurora, UT?

Select your specific project to find the pro for you.

Find Electricians in Aurora

Avatar for Hollis Electric, LLC
Hollis Electric, LLC
5.0(
1
)
Electrical Wiring or Panel UpgradeElectrical Wiring or Panel Upgrade - For BusinessElectrical for Addition or Remodel - Install - For Business+1 more

Serving Aurora, UT and surrounding areas

Approved

In business since 2021

Free estimates

Emergency services offered

Hollis Electric is committed to excellence in every aspect of our business. We uphold a standard of integrity bound by fairness, honesty, and personal responsibility. Our distinction is the quality of service we bring to our customers. Accurate knowledge of our trade combined with ability is what makes us true professionals. Above all, we are watchful of our customers' interests, and make their concerns the basis of our business.

Response time3 hrs
Response rate100%
Avatar for Emco Heating & Air
Emco Heating & Air
4.8(
6
)
Appliance (Major Electric Appliance) - Install or Replace

Serving Aurora, UT and surrounding areas

In business since 2003

Credit card accepted

"emco arrrived at my home at the exact time they said they would. workers wore boot covers to protect my floor coverings. they completely explained what they would be doing and showed me the defective part. workers were uniformed, clean cut and very professional . i would definitely recommend this company.
"
Additional Photos
Recommended by100%of homeowners
Showing 1-10 of 27
Electrical questions, answered by experts

The key difference between a circuit breaker versus a surge protector is that circuit breakers shield your entire electrical system from overcurrents and faults, while surge protectors defend your electronic devices against voltage surges and spikes. A circuit breaker interrupts the flow of electricity in a circuit when it detects an overload or short circuit, protecting the wiring from damage and preventing fires. In contrast, a surge protector shields electronic devices from voltage spikes, such as those caused by lightning strikes or power surges, preventing damage to the device’s inner mechanics.

Many wire nuts can accommodate three wires of various gauges; you should check the packaging of the nut to confirm you are buying the correct size. In addition, there are screw terminals that accommodate various numbers of wires; these might also be called “terminal blocks,” and exist to connect multiple wires. 

A 60W LED bulb is likely labeled as “60W replacement” on the package—that’s because it provides about the same light output as a 60W incandescent bulb. In reality, it likely uses less energy—usually 15 watts or less. If that’s the case, then it’s perfectly fine to put a 60W LED bulb in a 40W socket. Your best bet is to read the package carefully. It will tell you the LED bulb’s actual wattage, and as long as it’s lower than the fixture, the bulb will be safe to use.

If the electrical wires you’re working with are too short, one of the easiest ways to elongate it is to extend them with a push-in connector. These user-friendly tools help you splice two wires together with little fuss or the need for extra tools, like a crimping tool, which is an older way of extending wires. As long as you can stripe the ends of a wire, using a push-in connector shouldn’t be an issue.

Yes, states and local governments can have additional building codes that address kitchen outlets. In most cases, these kitchen outlet codes simply refer to the NEC. However, states or local municipalities can have separate requirements for electrician licensing, such as requiring a permit to make big changes, and other details.

The Aurora, UT homeowners’ guide to electrical services

From average costs to expert advice, get all the answers you need to get your job done.