Top-rated affordable plumbers.

Get matched with top affordable plumbers in Beaver, UT

Enter your zip and get matched with up to 5 pros

Need a pro for your affordable plumbing project in Beaver, UT?

Select your specific project to find the pro for you.

Find Affordable plumbers in Beaver

Avatar for Mr. Rooter Plumbing of St. George
Mr. Rooter Plumbing of St. George
4.5(
164
)
Plumbing for a Remodel or Addition - InstallFaucets, Fixtures and Pipes - Repair or ReplaceGas Piping+23 more

Serving Beaver, UT and surrounding areas

Approved

In business since 2004

Free estimates

Emergency services offered

"Josh was fixing the cartridge on the Bathtub, He was not very personable we felt. He fixed the bathtub and went back out the The door without a word to us. The other guy nick was walking around checking the other water fixtures in the house, felt he was upselling to much. The problem was fixed to our satisfaction after we ourselves checked it out. Nick was very nice, but felt we were being pushed to do other things in our home. Found out that rooter plumbing guys work on commission."
Thank You
Mr Rooter Plumbing
Our Angi Page
Camera Main line
Broken sewer line

+9

8 neighbors recently requested a quote
Recommended by92%of homeowners
Avatar for Bath Fitter Utah
Bath Fitter Utah
4.4(
30
)
Bathtub Install or ReplaceBathtub Install or Replace - For BusinessShower Install or Replace+2 more

Serving Beaver, UT and surrounding areas

In business since 1984

Free estimates

Emergency services offered

"We had them come and give us a quote to put a bath fitter in a compact shower. To be fair, we also asked them to raise the ceiling height to match the rest of the bathroom as the shower had a drop ceiling which I expected to cost a little more. The lady who came was extremely professional, timely, and well organized. I will say I was a tad shocked though when the quote was a little over $7800. We ended up going with a different contractor who redid the shower with tile and redid another bathroom floor for over $1000 less than the bath fitter quote for the shower alone. I would say this company would be a better fit for a more basic job. They did have really nice, stylish design options for this type of shower."
Additional Photos
Additional Photos
Additional Photos
Recommended by91%of homeowners
Avatar for Bathworx Inc.
Bathworx Inc.
5.0(
3
)
Walk In Tub - Install or Replace

Serving Beaver, UT and surrounding areas

In business since 2023

Free estimates

Warranties offered

"The possibilities are endless with design and products, and pricing was affordable. Very experienced workmanship and knowledge made this project easy and enjoyable. We highly recommend BathWorx and have plans to use their services again at our summer home remodeling project of two bathrooms."
Shower in Veincut Gray
Golden Beaches with Designer border
Shower1
White Pearl
Brecia wall panels with wainscoting

+1

Response time3 hrs
Response rate100%
Recommended by100%of homeowners
Replumb Specialties Inc.
3.9(
9
)
Drain Line Breakage - Camera LocateDrain Line Breakage - Camera Locate - For BusinessFaucets, Fixtures and Pipes - Repair or Replace+6 more

Serving Beaver, UT and surrounding areas

In business since 1992

Free estimates

Warranties offered

"RSI is a great replumb company. The actual replumbing was outstanding and we opted for the upgraded pro-plex fittings to increase our warranty from 10 to 25 years (not an up sell by Jamey - our choice). They also put in-place a dedicated recirculation line for our tankless water heater. The RSI team (Kenny and Milo) was expert at locating and replacing the old polybutylene piping with minimal impact to sheetrock, tiles, and fittings. They finished the work early but were delayed in finalizing the project due to a delay from the Regional Building Inspectors, not RSI's fault. Our only suggestions are 1) better daily clean-up, 2) better attention to detail repainting sheetrock (we had to repeatedly point out areas for a 'redo' and adjacent areas for touch-up) - this seemed harder to do that we expected (this is why we gave them a B rather than an A for quality). Jamey was very responsive to us and answered our questions/concerns thoroughly and promptly. We will recommend RSI our neighbors and friends.
"
Recommended by85%of homeowners
Showing 1-10 of 31
Affordable Plumbers questions, answered by experts

If you're dealing with a clogged sink drain, you may be able to avoid removing the drain by using a plunger to dislodge the clog. While we associate plungers with toilets, they can do the same job with your sink drain. Be gentle, though, as forceful movements can push clogs further into your plumbing system and make them more difficult to remove. Additionally, make sure you’re using a sink plunger—with a flat bottom—and not a toilet plunger—which has a smaller bottom protruding from the larger flat piece.

You could be smelling sewer gas in your kitchen because of a dry P-trap, clogged vent pipe, or leaking plumbing seals. If you smell a rotten egg odor, check your sink’s P-trap and plumbing connections first. A clogged or damaged vent pipe can trap sewer gas and push it back into your kitchen through the plumbing pipes. Loose or deteriorated seals around drainpipes can also allow sewer gas to leak out. If you can’t find the source, call a local plumber for expert help.

The standard size of a pipe for the main water line ranges between 3/4 inch to 1 inch in diameter, but ultimately, the size will depend on your household size and its square footage. Depending on the size of the property, the water line size can range upwards to 1.5” in diameter for a very large house nearing 10,000 sq. ft. Incorrect pipe sizing can lead to potential damages and leaks. To avoid incorrect sizing, consider getting help from a local plumbing professional who can help you choose the right size and material for your pipe.

If you go to turn it counterclockwise and it won’t turn anymore, it’s open. Like most other valves, you should be able to turn a radiator valve counterclockwise (to the left) to open it and clockwise (right) to close it. To close a radiator valve, turn it clockwise until you meet some resistance and can’t turn anymore, but do so carefully to avoid breaking the valve.

Even though their jobs sound similar—both professions work on pipes—a plumber and pipefitter actually have very different jobs, and pipefitting isn’t considered plumbing. Pipefitting is done in commercial and industrial buildings and factories, and the pipes carry gas, chemicals, acid, and other potentially hazardous substances. Pipefitters often work in intense conditions while plumbers may work in lower-pressure environments.

The Beaver, UT homeowners’ guide to affordable plumbing services

From average costs to expert advice, get all the answers you need to get your job done.