"Excellent company to do business with. Ed is awesome. Explains job and how everything works. And the work is done quickly professionally & with care for my property. Would hire again -- and will be!!"
"John Corrigan and his sons are outstanding! They did outstanding work installing our lighting rods at a reasonable price. They were prompt, very professional and honest. I would call them again and recommend them to anyone."
"We were contacted immediately regarding adding a lightning protection system on our home. Seamus was very thorough and knowledgeable regarding our concerns. He and his crew showed up and were very professional and efficient. We are very pleased with the installation and highly recommend Donahue’s."
"The problem turned out to be a burned out small electric door switch. I believe the price was way too expensive for the service performed and the price of the door switch. What more can I say? It got done."
"Jim Benton of Country Boys Electric came out the day after my call for a bid. He walked through our shell of a log cabin in the woods, was very thoughtful, made many great suggestions about where to put lights and plugs, described the work they would do and within a few days we has his written bid. We liked and trusted Jim immediately and they started to work in a few days. His workers were very professional, arrived on time, worked well with us. They did all the wiring and then had to wait about a month for the sheetrock and painters to do their work. We called them back and they were ready to install lights and fans and finish the job. We were so please with their work. They were very reliable and on time, even though they had to drive 40 miles from their shop to our place each day.We would highly recommend them to others. "
"My house was under construction. and had already gotten struck by lightning so time was critical as I knew it could happen again. I have a home with tall roof peaks and built on a hill. They came out quickly and started right away and their prices were way less than the other company s. I will use them again when my barn is constructed."
"I have had my Aztec Renewable Energy solar panels for over two years, and I am very pleased with the performance of the equipment as well as the whole process. Upon activation of my system, my average monthly electric bill went from over $150 to under $15. Additionally, it has required no service or maintenance. The initial sales call was low pressure, and Charles took the time to educate us regarding the use of solar energy. The cost of the installation was exactly what was quoted; and the installers were professional, experienced, and very proficient. The system is functioning just as efficient as it did on day one. I would recommend solar panels to save money and do good for the environment. I recommend Aztec because of their expertise and courtesy."
Usually, a light switch goes bad due to normal wear and tear. Light switches are mechanical devices with internal moving parts. These parts make contact with each other, and, over time, the friction can wear them down, causing the switch to feel loose, arc, or fail to operate.
No, wiring does not need to be redone to get a dimmer switch, as they work with single-pole and three-way switches. Just ensure you choose a dimmer that is compatible with your wiring, fixture, and lightbulbs. Most homes built after 1985 have neutral wiring and work with almost all dimmers. If your home was built before 1985 and you don’t have an updated electrical system, you may have to use a non-neutral wiring dimmer.
If you need to run a wire from the meter to the breaker box, start by turning off the power using the main switch to avoid injury risks from live wires. Then, locate the ground wire from your meter and connect it to the ground bar of the breaker box. Connect the neutral wire using the same method to improve your circuit efficiency.
Next, locate the hot wires running from the main switch to the meter. To connect them to the correct terminals from meter to breaker, unscrew the nuts of the breaker hotwire terminals, insert the positive hotwire, and ensure it’s firmly attached. Finally, secure the wires with electrical tape and wire tie cables before re-securing your breaker box. Keep in mind that this process can be dangerous, so don’t hesitate to hire a local electrician.
Electrical meter risers connect your home’s electrical meter to overhead power lines so you can receive electrical service from the grid. Electrical meters also have a weatherhead, which protects the utility lines connected to your home’s electrical system via the service entrance cable. Risers connect the weatherhead to your electrical meter socket, which connects to the meter.
Multiple wire sizes are used for residential electrical purposes. While the most common sizes used in homes are 14 and 12 gauge, some appliances, such as stoves, electric water heaters, central air units, etc., may use larger gauge wire to accommodate their larger amperage. Typically, larger appliances require 10-, 8-, or 6-gauge wires.
The Wellington, TX homeowners’ guide to electrical services
From average costs to expert advice, get all the answers you need to get your job done.
Before you hire a licensed electrical contractor, you should learn the cost to run electric from the road to your house so you can budget for the project.
Is it time to upgrade your electrical panel? For the sake of safety, find out sooner than later by exploring our top signs that it’s time for an upgrade.