Top-rated electricians.

Best electricians near Odem, TX

Enter your zip and get matched with up to 5 pros

TRUSTED BY ODEM, TX HOMEOWNERS

  • Average homeowner rating star icon4.6
    Average homeowner rating
  • Verified reviews icon121
    Verified electrical services reviews

Top-Rated Electricians in Odem - Updated Nov 2026

Avatar for Hamilton Lightning Rods
Hamilton Lightning Rods
4.7(
203
)
Lightning Protection - Install or Repair

Serving Odem, TX and surrounding areas

Approved

In business since 1969

Free estimates

Emergency services offered

"Lightning rod installation in 2022 and the work was done flawlessly, the technicians were professional, left my property clean and tidy and the work they did looks appealing. My total cost was less than $3k and it was worth every penny as two other houses in my neighborhood got striken and burned."
Lightning Protection
 Lightning Protection
 Installing A Lightning Rod
 Lightning Protection
 Lightning Protection

+9

Response time3 days
15 neighbors recently requested a quote
Recommended by96%of homeowners
...
Showing 1-10 of 120
Electrical FAQs, answered by experts

A gas stove doesn't always need a dedicated circuit. Unlike an electric range, which uses 240 volts and requires a 240-volt receptacle, a gas stove only uses 120 volts. In some cases, your electrician will need to replace the existing two-pole circuit breaker with a single-pole circuit breaker as well as swap out the existing 240-volt receptacle with a 120-volt replacement.

Most 200-amp panels have 40 to 42 slots, which can accommodate 40-42 single-pole breakers or 20 double-pole breakers. Some panels can accept even more circuits through the use of tandem breakers. The exact number of breakers allowed is determined by the panel manufacturer's rating, which you can find on the panel itself. It is important to avoid using all breakers at the same time; as a general rule, you should not use more than 160 amps of power at once to prevent overloading your 200-amp system. For specific guidance, it's best to check your panel's rating or consult with a qualified electrician.

Homeowners insurance policies will typically cover your cost to replace an electrical panel if damage occurs due to a covered circumstance such as fire, lightning, or certain types of accidents. Regular wear and tear or damage due to neglect might not be covered, so it's essential to review the policy details and consult with your insurance provider on the specifics of your coverage.

While washers and dryers do not require a GFCI (ground fault circuit interrupter) outlet to function properly, electrical codes often mandate their use for safety. The National Electrical Code (NEC) requires GFCI protection for all outlets within six feet of a water source. This means a washer and dryer must be plugged into a GFCI outlet if they are installed in locations like a laundry room, utility room, garage, or basement. In other areas without a nearby water source, there is no specific requirement, but using a GFCI outlet is still recommended for extra peace of mind. It is always best to consult your local codes and regulations to ensure compliance and safety.

Let them know exactly what type of job you need them to do, and be as specific as possible to get the most accurate estimate. A photo of your project might help them better understand your needs. Ask what kind of prep you should complete before they visit and what kind of cleanup to expect after the visit. Finally, ask how long the project usually takes.

The Odem, TX homeowners’ guide to electrical services

From average costs to expert advice, get all the answers you need to get your job done.