"Great. The investigation process quickly isolated the microwave (and its previous substandard installation) as the primary issue. Complete home electrical review process provided wealth of info to make schedule next steps."
"These guys fixed my electrical issue the right way instead of the wrong way that my previous electrician had. Very professional and informative. Will be my go to service from now on."
"Was very knowledgeable about all the current code requirements and necessary equipment needed to install and even walked me through the start up procedure after the install was complete. Will definitely call him back for future work"
Tri-State Water, Power & Air has been provided products designed to improve the comfort and quality of life of our customers since 1992. Our specialty is Automatic Home Standby Generators. \nWe expect customer service excellence and aim to go above and beyond on every call. With 10 locations across 8 states, Tri-State is always ready to serve you.
Technically, an outdoor outlet can be on the same circuit as an indoor outlet, but it's generally not recommended. Outdoor outlets should ideally be on a dedicated circuit that doesn't share power with other indoor or outdoor outlets. This helps ensure that the outdoor outlets are able to handle the additional electrical load without overloading the circuit. Additionally, outdoor outlets are often exposed to the elements, which can increase the risk of electrical shock and other hazards. If you must have an outdoor outlet on the same circuit as an indoor outlet, be sure that the circuit has the capacity to handle the additional load.
No, because amps and volts measure very different things. However, you can use basic equations to find amps or volts by using data about one of the measurements to calculate the other.
It’s not recommended to turn off your breaker box in hopes of saving electricity. Breaker boxes were not designed to constantly be switched on and off. Therefore, turning off breakers unnecessarily can cause costly damage that outnumbers any energy savings. Only flip your breakers if absolutely necessary when troubleshooting an electrical issue.
Yes, a light switch still has power even when switched off. Switches only interrupt or continue the flow of electricity into a fixture or outlet; they do not shut off the power flowing into the wire. The only way to shut off power in a light switch is to turn off the power at the circuit breaker.
You can determine whether you have a double-pole switch by examining its wiring. Unlike single-pole switches, which have two brass-colored terminals, double-pole switches feature four. These switches are typically only found near high-powered appliances such as electric furnaces or water heaters. If you’re unsure what type of switch you have, contact a local electrician to confirm.
The New Fairview, TX homeowners’ guide to electrical services
From average costs to expert advice, get all the answers you need to get your job done.
Before you hire a licensed electrical contractor, you should learn the cost to run electric from the road to your house so you can budget for the project.
Is it time to upgrade your electrical panel? For the sake of safety, find out sooner than later by exploring our top signs that it’s time for an upgrade.
