Get matched with top pressure washers in Springfield, SD

Pressure washing your driveway can prevent cracks in it since it removes grease and oil, which, if left on the driveway for too long, can break down compounds in concrete and asphalt, leading to cracks. It can also help keep driveway weeds, moss, mold, and mildew at bay while boosting your home's curb appeal. 

This answer is a bit tricky because experts say both. You should apply your cleaning solution from bottom to top, but rinse from top to bottom to avoid streaking. When it comes to multi-story houses, you’ll want to start at the top floor and work your way down, but follow the above instructions for each level as if it were an independent structure, rather than washing the whole house as one unit.

Brick takes longer to dry than less porous materials like concrete. If you are waiting to spot clean, a full day of mild weather should do the trick. If you are waiting to paint or apply a finish or sealant, give it three to four days to ensure the brick is absolutely dry as a bone. You don’t want any residual moisture whatsoever before laying down paint or sealant. 

You can get more pressure out of your pressure washer by adjusting the pressure control knob clockwise to increase pressure (+). You can also check your nozzle for debris and clogs and remove anything you find with needle nose pliers. Switch to a nozzle with a lower-degree spray angle or a turbo nozzle to achieve more pressure at the tip. Check for leaks in the hose and connections, and make sure your water supply is offering enough pressure.