Get matched with top water softener pros in Eureka, SD

It’s not a good idea to oversize your water softener. Doing so will mean the tank doesn’t get full, which can lead to channeling. This leads to a large portion of the resin beads not being utilized and the beads at the bottom of the tank being overused. Over time, this will reduce the efficiency of your system, not to mention that the upfront cost of an oversized softener is unnecessarily high. If you have a timed regeneration cycle rather than a demand-based one, you’ll also spend far more on replacing salt than you need to.

Routine maintenance involves recharging the resin bed with salt or potassium, cleaning components, and periodic inspection.

Experts recommend that you put two to four bags of potassium chloride in your water softener every month. This amount depends on how much is in the bag (40 pounds is most common) and what your water softener manufacturer recommends. For more specific advice, talk to a water softener pro in your area and read the manual that came with your system.

You can install a water softener system by turning off the water supply, draining the water, and then connecting your device to the waterline. Next, you’ll fill your tank with the recommended amount of salt or brine (whichever your unit calls for; be sure to read the instructions). Turn the water supply on and check for leaks. You can opt to let your water run for a few minutes, then test it using strips. 

The process of inspecting your water softener system is similar.