Get matched with top water heater pros in Clark, SD

It is very difficult and dangerous to install your own water heater, so we strongly recommend against tackling this as a DIY project. Not only will you need to wire your water heater, but you’ll also need to connect plumbing to the intake and outlet. Sweating copper pipes and connecting wiring properly are skills most DIYers don’t have, and even if you do feel confident you can do it, working with water and electricity always leaves the potential for electrocution. Hiring a local water heater installer is well worth the investment.

Most hot water heater manufacturers recommend replacing the anode rod about once every three to five years. Anode rods sacrifice themselves by collecting iron, limestone, and other minerals that would otherwise corrode your hot water heater tank. This abuse wears them out long before your water heater does. Check the rod when you remove it and replace it if more than 50% of the metal has been consumed. Check the rod more frequently if you have hard water or use a water softener. 

Yes, hybrid water heaters can be noisy — noisier than traditional water heaters. The sound they produce is often compared to the hum of a dishwasher. Its noise comes from the heat pump’s fan and compressor as they work to pull in and compress the air. While it’s not totally disruptive, especially if the unit is installed in less frequented areas, like a basement or garage, it’s something to keep in mind if you’re sensitive to noise or if the unit will be placed near bedrooms or living spaces.

Yes, you can replace a current tank water heater with a tankless model or vice versa. If you’re maintaining the same fuel source—gas or electricity—the switchover should be smooth. A conventional tank requires open floor space, while a tankless model can be wall-mounted. If you’re switching to a tank water heater, you might need to clear space for it. Gas-powered tankless water heaters need a large volume of gas when they start running to heat the water instantly. You might need to increase the size of the gas line when going from a tank to a tankless model.