Top-rated sandblasting pros.

Get matched with top sandblasting pros in Shulerville, SC

Enter your zip and get matched with up to 5 pros

Need a pro for your sandblasting service project in Shulerville, SC?

Select your specific project to find the pro for you.

TRUSTED BY SHULERVILLE, SC HOMEOWNERS

  • Average homeowner rating star icon5
    Average homeowner rating
  • Verified reviews icon16
    Verified sandblasting services reviews

Find Sandblasting pros in Shulerville

Avatar for Jays Plumbing Solutions
Jays Plumbing Solutions
5.0(
11
)
Exterior Surfaces - SandblastingExterior Surfaces - Sandblasting - For Business

Serving Shulerville, SC and surrounding areas

Free estimates

Emergency services offered

Credit card accepted

"It went extremely well and I’m very happy with the work. Jay did a waterline re-pipe of my home and my water pressure has never been better. Extremely happy with the customer service and the communication with each step along the way. I have referred to friends and family."
Well Pump remove and replace
New connection at the front of the home right before the foundation footer. (As
Close to the home as possible.
Main sewer line
Main sewer line repair from clean-out to city pipe.
New drain lines in after cleanup of excrement and old lines.

+86

Recommended by100%of homeowners
...
Showing 1-10 of 64
Sandblasting Services questions, answered by experts

Your pro will most likely bill you at an hourly rate of $50 to $80 per hour to sandblast a door due to its small size. This type of job won't take long, so if you have other surfaces that need cleaning, schedule those tasks at the same time to get your money's worth from your pro's visit.

The cost of sandblasting depends on the scope of the project, the surface type, labor, and equipment required. Services typically cost between $50 and $80 per hour, though most professionals charge by surface area at a rate of $1.50 to $7 per square foot. Total project costs can range from $700 to $12,500, with an average homeowner spending around $3,200 to sandblast a 1,000-square-foot surface.

The best way to sand a deck is by cleaning it, sanding the boards and stairs with 60- or 80-grit sandpaper, and sanding the railings and posts with 80-grit sandpaper. You should sand in the direction of the wood grain to avoid damaging the timber. When sanding your deck, use medium pressure and aim for an even sand. Pressing too hard with a sander can damage decks, as most are softwoods.

Yes, many professionals use dustless or water-based blasting methods for reduced environmental impact.

Soda-blasting systems are slightly more expensive than sandblasting systems. To soda blast, you’ll need to spend a few hundred dollars for a blast hose and nozzle, a compressed air supply, a blast generator, a moisture decontamination system, and sodium bicarbonate media, a recurring cost because the powder is not reusable. To start with sandblasting, you will need to spend upwards of $30 for a blast pot, a blast gun, an air compressor, and sandblasting media, many of which are recyclable—further reducing the cost. The total cost for either will depend on the size of the system.

The Shulerville, SC homeowners’ guide to sandblasting services

From average costs to expert advice, get all the answers you need to get your job done.