Get matched with top fencing pros in Seven Valleys, PA

In most cases, you will need a building permit to put up a vinyl fence, especially if the fence is sitting on or close to your property line. You can ask your local building department or  fence installation company if your fence project will require a permit. If so, you can expect it to cost between $20 and $60. Your fence installer should pull the permit for you. Building without a permit could eventually require you to pay again to remove the fence and reinstall it after getting the job approved.

Privacy fences in residential neighborhoods tend to stand between 6 and 8 feet tall, but local building code usually dictates the maximum height. Livestock fences that border large land plots range from 3 to 6 feet. Shorter, decorative fences, which are common in front yards, are around 3 feet tall, on average. Fence height also tends to vary by material, with wood fences usually sitting at 6 feet tall, and chain-link and wrought iron fences tending to sit at half that.

If you don’t have a pressure washer or simply don’t want to lug it out of storage, you can spot-clean your wood fence with a garden hose instead. Apply your mild detergent with a soft cloth, scrub with a broom or other soft-bristled brush, and rinse with a garden hose.

To choose where to add a fence gate, know where fence gates shouldn’t go. For example, you should avoid placing gates over low spots on the ground where water can collect and form muddy puddles. Many ranchers install gates at the corner of a fence. Certain gate placements may also be required depending on the type of gate latch you use.