Best electricians near Myerstown, PA

Yes, pool pumps use a significant amount of electricity, making them one of the biggest energy consumers in a home. A pool pump can use up to three times as much electricity as a refrigerator. Typically, a residential pool pump consumes about 1 kilowatt-hour (kWh) for every hour it runs. Because pumps often need to run for about eight hours a day to properly filter the water, this can add up to an annual consumption of 3,000 to 5,000 kWh, which can cost between $480 and $800 per year based on average electricity rates.

The amount of electricity your pump uses depends on its size, energy efficiency, and daily run time. To lower your energy consumption, you can choose an energy-efficient or variable-speed pump, ensure it is correctly sized for your pool, and run it only for the minimum time required to keep the water clean.

It’s important to ask an electrician a few questions before you commit to hiring them so you can make an informed decision as a consumer. If you’re getting estimates or considering hiring an electrician, ask them these questions:

• Are you a full-time electrician?

• Are you bonded, licensed, and insured?

• What level of experience do you have as an electrician?

• Can you please share three references?

• Do you do residential or commercial electrical work?

• What kinds of electrical work are you most familiar with?

• Will any subcontractors be performing the work?

• Are permits and inspections required?

• Who is responsible for obtaining permits and inspections?

• What is your schedule?

• Do you offer a guarantee or warranty on your work?

• Will you sign a do-not-exceed clause to keep the job within the budget?

It might seem tempting to use 14-gauge wires for your outlets, as they can run a little cheaper. But, when it comes to electrical work, it’s best not to cut costs less you overload your circuit. A 12-gauge wire will ensure that you’re protecting the outlet (and your circuit breaker) from any potential overloads that might incur, as it can handle a little more amplitude than a 14-gauge wire.

Yes, a whole-house surge protector needs a designated breaker in your electrical panel. You will need to choose a double pole breaker that has two wire terminals so that your surge protector can connect to the breaker. This breaker needs two breaker slots inside of your panel. If you do not have room, then you will either need to adjust some of the existing breakers in the panel box or hire an electrician to install a subpanel.