Top-rated welders.

Get matched with top welders in Morgantown, PA

Enter your zip and get matched with up to 5 pros

Need a pro for your welding project in Morgantown, PA?

Select your specific project to find the pro for you.

Find Welders in Morgantown

Avatar for Schultz Design & Fabrication
Schultz Design & Fabrication
5.0(
5
)
Metal Stairs and Railings - RepairMetal Structure or Object - Create CustomSheet Metal and Ornamental Metal - Fabricate

Serving Morgantown, PA and surrounding areas

Approved

In business since 2020

Free estimates

Credit card accepted

"I cannot be happier with this pro. I highly recommend him. He underpromised and overdelivered. He installed a metal spiral staircase by Paragon stairs: They did an exceptional job. Flawless. They took the time to measure and level every step. Drove from an hour away.outstanding quality and customer service: I have done a lot of remodeling over time and I would give them a 10 star if I could!"
Response time5 hrs
Recommended by100%of homeowners
William Staniscia
4.2(
15
)
Steel Beams (Structural) - Install

Serving Morgantown, PA and surrounding areas

Approved

In business since 1990

Free estimates

Offers commercial services

"I didn't know how I was going to resolve my home improvement project. Bill contacted me immediately after visiting Home Advisor. He was professional, courteous and eased my need to continue searching for a home improvement contractor. I strongly recommend him."
Response time2 days
Response rate100%
9 neighbors recently requested a quote
Grady's Painting Plastering/Construction
2.0(
174
)
Wrought Iron Fence - Repair or Weld

Serving Morgantown, PA and surrounding areas

Approved

In business since 1969

Free estimates

Emergency services offered

"I needed stucco repair work on an old chimney (and other spots). Grady was meticulous and thoughtful on what approaches and materials would work. Throughout the project they allocated sufficient time for each treatment to cure and inspected the work before proceeding to the next step. Grady started the project with no money down and only required ongoing payments for materials until the project was well underway. The final payment was due only after they did a final inspection. Total project cost was also below other bids."
Response time11 hrs
Response rate100%
Recommended by57%of homeowners
...
Showing 1-10 of 104
Welding questions, answered by experts

Yes, you can cut up a box spring., but you’ll need to do so in layers. You can clear the fabric and fluff away to reveal the springs before removing them as well.

Yes, you can use a saw to cut metal pipes. The best saw to use is a reciprocating saw, but even a fine-tooth hacksaw can get the job done. No matter which saw you use to cut metal pipes, wear protective gear, like work gloves, safety goggles, and ear plugs. Apply a firm, steady pressure to the tool, and always ensure the pipes are secured so they don't move while you make the cuts.

While a high-speed circular saw will cut through metal, and even cut through multiple sheets at once, the fast-spinning saw blades create a lot of heat. This heat can damage paint and other protective coatings, leading to serious problems like rust over time. The cost to paint a metal roof again to avoid this damage is typically an additional $0.50 to $1 per square foot.

Your typical household tools will not cut a metal pipe. To cut a metal pipe, you’d need more specialized tools like a pipe cutter or circular saw. Do not attempt to use these tools without taking proper safety precautions and wearing safety gear. It’s usually safer to let a pro cut a metal pipe, especially if you’re not confident in your skills with a heavy-duty saw.

Yes, you can cut plexiglass by hand using a sharp knife or blade (utility knife, box cutter, glass cutter, etc.).

The Morgantown, PA homeowners’ guide to welding services

From average costs to expert advice, get all the answers you need to get your job done.