Get matched with top affordable plumbers in Limestone, PA

You can adjust the mixing valve on your shower if it uses a single handle to control both hot and cold water by removing the handle and adjusting the cap on the mixing valve. The cap fits over the valve handle and creates a low and high point for your handle to spin. Remove the cap and turn it to adjust how it mixes hot and cold water, and then replace the cap and reinstall the handle.

Yes, you can fill your toilet tank manually to help it flush, or you can pour the water directly into the bowl to flush it manually. This will work for the majority of toilets, as most use a gravity feed system. However, you should only ever use this as a temporary solution. If your toilet tank isn’t filling, you should find out why. First, make sure the speedy valve connected to your toilet and your water main are open. If that doesn’t solve the issue, call in a professional to address the problem.

If a bolt at the bottom of your toilet tank is loose, it can directly cause a leak. If a bolt securing the toilet base to the floor is loose, it won’t directly cause a leak but can lead to the same result over time. That’s because the loose bolts will eventually move the wax seal or cause cracks in the bowl from the toilet being wobbly.

If your sink is on an exterior wall that isn’t insulated, or if pipes travel through a cabinet against an exterior wall that prevents heated air from circulating around the pipes, the pipes can freeze, causing them to burst. The best way to avoid leaking sinks is to insulate the pipes and open cabinets in the short term to warm the water line up and prevent freezing.