Get matched with top insulation pros in Hawley, PA

Although spray foam insulation typically has a higher price point than traditional insulation, the benefits often justify the investment. It offers superior sealing properties, which can lead to significant energy bill savings. Spray foam also provides excellent moisture resistance and soundproofing. Other advantages include improved indoor air quality by minimizing allergens, a long lifespan of 80 to 100 years, added structural strength to the home, and a straightforward installation process.

On average, insulating an attic costs about $2,500, with a typical range of $1,500 to $3,500. The final price often depends on the attic's size, with costs generally falling between $1 to $3 per square foot. For example, insulating a 1,800-square-foot attic would likely cost between $1,800 and $5,400.

If the project involves removing old insulation, this can add an average of $900 to the total cost, bringing a full removal and reinsulation project to around $3,000.

Several factors influence the overall cost:

• Insulation Type: Prices per square foot vary significantly by material.

• Reflective: $0.50–$1.50

• Blown-in: $1–$4

• Batt: $2–$4

• Loose-fill: $2–$5

• Spray foam: $2–$5

• Structural insulated panels (SIPs): $4–$7

• Project Complexity: Factors like sealing air leaks, poor attic accessibility, and required inspections can add to the cost.

• Removal Issues: The discovery of mold, asbestos, or pests during the removal of old insulation can substantially increase the price.

Yes, insulating hot water pipes helps your system run more efficiently. This is especially true in basements in colder climates, where cold air likes to settle in. There are a few ways to insulate water pipes (foam is common) to keep hot water hot, reducing the need for your water heater to constantly heat the water in the tank or your circulator to kick on more than necessary.

The most obvious con of injection foam is the cost. It’s much more expensive to install than fiberglass or spray foam, but it may be your only option (unless you want to remove entire walls around the home). Another con is that it involves drilling into existing material, which has to be repaired after the foam is injected. Some injection foams are made from products that aren’t environmentally friendly, and improper installation can lead to trapped moisture, which can lead to expensive mold remediation down the road.