Get matched with top pool table assembly pros in Danielsville, PA

A good rule of thumb is to add one or two 40-pound bags of salt for every inch of rain, but you’ll want to test your salt levels first to ensure you’re adding the right amount. Rainwater can dilute the salt levels in your pool, so after significant rainfall, test the levels and add the appropriate amount of salt to bring it back to the ideal level.

Yes, pool pumps use a significant amount of electricity, making them one of the biggest energy consumers in a home. A pool pump can use up to three times as much electricity as a refrigerator. Typically, a residential pool pump consumes about 1 kilowatt-hour (kWh) for every hour it runs. Because pumps often need to run for about eight hours a day to properly filter the water, this can add up to an annual consumption of 3,000 to 5,000 kWh, which can cost between $480 and $800 per year based on average electricity rates.

The amount of electricity your pump uses depends on its size, energy efficiency, and daily run time. To lower your energy consumption, you can choose an energy-efficient or variable-speed pump, ensure it is correctly sized for your pool, and run it only for the minimum time required to keep the water clean.

Aboveground pools take between one day to a few days to install, depending on the pool size and type. Your project may take longer if you’re planning to complete other projects simultaneously, like building a deck around the pool. If your land is hilly or rocky, you’ll also need to budget time for the land preparation. Aboveground pools need to be installed on a level surface.

Don’t worry if your pool is still cloudy right after shocking it. Some shocking products will leave your pool cloudy for a day or so after using them. However, if your pool is still cloudy several days after shocking it, it could be due to poor filtration, low chlorine, or one of the other problems outlined above. If you’ve tried our fixes but still can’t clear the cloudiness, call a pool repair professional.