Get matched with top above ground pool installation pros in Corry, PA

Any number between 7.2 and 7.8 is an ideal pH for swimming pools or 80 to 120 ppm. Your pool testing kit should be able to measure both of these numbers. If your pool’s pH is below this range, the water is too acidic and can cause scaling and damage to pool equipment. If the water’s pH is above this range, it can decrease the effectiveness of necessary chemicals, like chlorine.

You can install an aboveground pool on various surfaces, including dirt, sand, concrete, and grass. You can’t install a pool on an uneven surface, though, so be sure to level the ground before building your pool. You also can’t install your pool on top of a rocky surface. Three or 4 inches of smooth sand or soil is the ideal surface to go under an aboveground pool.

Because they are smaller than an average-sized swimming pool, building a plunge pool is less costly than a traditional pool. In-ground swimming pools cost about $67,000, while plunge pools cost around $20,000. You won’t have as much room to swim in, but the smaller size means you spend less on land excavation, materials, and hourly labor rates.

Your indoor pool can be heated or unheated, but the decision depends on your local climate. In regions with freezing temperatures, heating your pool will keep it warm during the winter, especially if it’s only covered with a greenhouse enclosure. 

If you keep your swimming water warm and toasty, budget between $300 and $5,700 for the cost of installing a pool heater.