Get matched with top concrete resurfacing pros in Crooked River Ranch, OR

"Skyler and TerraFirma far exceeded our expectations. The injection process of the foam raised our cracked garage floor back to level. Skyler’s customer service was the best. I highly recommend TerraFirma and hope that you get Skyler as the person doing the work… you will not be disappointed!"

"I want to thank Summit Concrete for the amazing job done on my driveway/RV parking. Sean was very easy to work with and when something came up I wasn't a fan of he walked me through possible solutions until I found one I was happy with. The work is everything I wanted. Highly recommend Summit Concrete LLC for any Concrete project. James "

"Very well - see above"

"Ted exceeded our expectations. We hired Ted to create a flat backyard and RV parking on our sloped property. Watching him excavate and move boulders with his equipment was like watching someone use a bionic arm to perform surgery. He removed our existing boulder wall, moved tons of dirt, and rebuilt the wall better than before, with little room for him to maneuver his equipment. We also had Ted dig trenches and remove part of our concrete foundation with great care to not damage the rest. He's talented, precise, creative, committed to do a good job and really pleasant to work with. We're extremely happy and highly recommend him."

"They did a wonderful job. They were very professional. We would highly recommend them and we would use them again."

"Jake was courteous, on-time and on-budget. He's an extremely hard worker and we couldn't be happier with the results."

"They were always on time and spent a lot of time fine tuning their work. They are good at communicating. Would definitely hire again."

"I was contacted by Abraham Torres in the Spring of 2022 to arrange for work to be completed from a bid he submitted on October 5, 2021. The work included completing three concrete aprons, one to replace the damaged attached garage driveway apron and other two were added as an entrance and exit for the shop lean-to. We arranged to begin the work June 21, 2022. He informed me that he and 3 additional individuals would arrive that day and begin prepping and setting up forms on the job site. I discussed with him and agreed to increases in material costs and a change from rebar to wire mesh, which increased the cost to $7000. The job proposal required 4 workers to complete the project in 3-5 days. Abraham and Gabriel spent only spent 1 day prepping and 1/2 day pouring and left their father, Gabriel Sr., and Omar, the younger brother, to finish the rest of the 2nd day. They failed to complete the remaining day(s) as per the estimate. There have been several different issues associated with the marksmanship of JG7 Concrete that surfaced during this project. First, concrete was splashed on the existing adjacent concrete slab in front of the shop door as well as the lower metal shop siding and corner mouldings of the lean-to. I had to purchase Liquid Hammer for $30 to remove the dried concrete splashed on the metal siding and corner mouldings. Secondly, I discovered that either the loader of their John Deere or jackhammer had damaged the bullnose edge of my interior garage concrete. I made it quite clear to Gabriel Jr. that there was absolutely no existing damage along that bullnose edge, other than a small chip under the south moulding. I advised him to be extra careful to avoid such damage while jackhammering and removing the concrete pieces. I subsequently called Abraham to inform him of the problem and requested he repair the damage. He claimed he would do so, made arrangements on two separate occasions to complete the repair, and never did so. My wife and I postponed a trip to Redmond during the second scheduled date and he failed to show, or even call. He’s made no subsequent attempt to complete the repair. Thirdly, Abraham apparently had no plans to backfill along the edge of each concrete apron, thereby leaving the edges of each apron exposed. His younger brother, Omar, attempted to do so the second day by going to Mathews Construction and getting substandard material (filter sand with a considerable amounts of rock) to utilize as backfill. It has subsequently compacted following rain and the grass refuses to take root in the sand. I will now have to hire a landscaper to bring in proper backfill soil to properly shore up the edges of the concrete and allow for proper germination and growth of the missing grass. Lastly, the concrete aprons on my garage and lean-to entrance puddle water. The water puddles on the sections of concrete between the joints and concrete edges because the concrete is pitched away from the edges of the apron and joints toward the middle of each concrete section. Even though JG7 Concrete is now working under a current Oregon Construction Contractors Board license, it was not doing so when they began the project. After they began on June 21, 2022, I discovered their CCB license had expired, even though I had previously made payment of the required 50% of the estimated amount. If you decide to use JG7 Concrete for a concrete project, you might wish to consider the following issues. Mask existing concrete and building surfaces to ensure splattered concrete can be easily removed or be prepared to remove such concrete before it dries. Make sure any damage created by JG7 Concrete to existing concrete or buildings is repaired prior to final payment. Ensure that the project is completed in its entirety. All backfilling and replacement of grass should be completed prior to final payment. Lastly, hold JG7 Concrete to their contract commitment. They should spend the time allotted as outlined in the contract, with the stated number of individuals to complete the project without shortcuts."