Get matched with top garage pros in Wagoner, OK

On average, RV garage doors are 12 to 14 feet tall to accommodate the large vehicles. Most RVs are approximately 9.5 feet tall but can be taller due to features such as air conditioners, satellite dishes, and luggage racks

We recommend plywood and solid wood. Particleboard and MDF (medium-density fiberboard) are often too weak to hold significant loads, and could sag or deform under pressure. Plywood or solid wood are meant to last, and can handle the weight of several large items. If you want to spend a little more for a moisture-resistant material, you can consider using steel.

No, there should not be a gap between your garage door and the floor. Gaps can make your garage less energy efficient, leading to higher energy bills. They also create an entry point for pests like rodents and insects, as well as rain and melted snow, which can lead to foundation damage or mold issues.

If you have a gap under your garage door, potential causes include an uneven garage floor or worn-out weather stripping. To fix it, you can try several solutions:

• Replace the weather stripping: The seal at the bottom of the door may need to be replaced.

• Adjust the garage door: You may be able to adjust the closing position on your garage door opener to eliminate the gap.

• Inspect the floor: If the concrete floor has shifted or is uneven, it may need to be repaired to create a level surface.

If these solutions do not resolve the issue, it is best to call a garage door repair specialist to inspect the door and floor.

Yes, you can pressure wash epoxy floors, but you must take precautions to avoid damaging the surface. While most epoxy floors can be cleaned with a mop, you might choose to pressure wash if the floor is stained, has ground-in dirt, or is covered with mold or mildew. To do so safely, first soak any stains or dirty areas with a gentle cleanser. Use a lower pressure setting with a gentle nozzle, such as a green, white, or black tip, or a 45-degree angled tip. Keep the spray nozzle at least 18 inches away from the floor to protect the surface. Using a surface cleaner attachment or a rotary scrubber can also help prevent overspray. Be cautious if using a power washer that heats the water, as the combination of heat and pressure may be too powerful and could damage the epoxy coating.