Get matched with top garage pros in Henryetta, OK

It is highly recommended to prime a metal surface, like a garage door, before painting. Primer creates a stable surface for the paint to adhere to, which helps prevent bubbling, chipping, and peeling. This ensures the paint job will last longer. Painting metal without a primer can lead to poor adhesion and allow rust to bleed through the new paint. If the surface already has rust spots, you can cover them with a zinc chromate primer before applying the final coat. While priming adds an extra step and cost, it is a worthwhile investment for a durable, long-lasting finish. For best results, also use a paint specifically designed for metal.

No, there should not be a gap between your garage door and the floor. Gaps can make your garage less energy efficient, leading to higher energy bills. They also create an entry point for pests like rodents and insects, as well as rain and melted snow, which can lead to foundation damage or mold issues.

If you have a gap under your garage door, potential causes include an uneven garage floor or worn-out weather stripping. To fix it, you can try several solutions:

• Replace the weather stripping: The seal at the bottom of the door may need to be replaced.

• Adjust the garage door: You may be able to adjust the closing position on your garage door opener to eliminate the gap.

• Inspect the floor: If the concrete floor has shifted or is uneven, it may need to be repaired to create a level surface.

If these solutions do not resolve the issue, it is best to call a garage door repair specialist to inspect the door and floor.

Yes, you can pressure wash epoxy floors, but you must take precautions to avoid damaging the surface. While most epoxy floors can be cleaned with a mop, you might choose to pressure wash if the floor is stained, has ground-in dirt, or is covered with mold or mildew. To do so safely, first soak any stains or dirty areas with a gentle cleanser. Use a lower pressure setting with a gentle nozzle, such as a green, white, or black tip, or a 45-degree angled tip. Keep the spray nozzle at least 18 inches away from the floor to protect the surface. Using a surface cleaner attachment or a rotary scrubber can also help prevent overspray. Be cautious if using a power washer that heats the water, as the combination of heat and pressure may be too powerful and could damage the epoxy coating.

If you open your garage manually, you don’t need sensors. If you have an automatic garage door opener, sensors are required by law. The federal law UL 325 mandates that all residential garage door openers in the U.S. must include sensors. Designed to prevent accidents and reduce the risk of entrapment, the sensors should be able to reverse the motion of the garage door within two seconds of detecting an obstruction. The sensors are there to keep you, your family, and your belongings safe from a door that might otherwise come down too hard or too fast.