Top-rated door pros.

Get matched with top door pros in Dover, OK

Enter your zip and get matched with up to 5 pros

Need a pro for your door service project in Dover, OK?

Select your specific project to find the pro for you.

Find Door pros in Dover

Avatar for GP Cabinets & More LLC
GP Cabinets & More LLC
New to Angi
Doors (Exterior) - Install or ReplaceDoors (Exterior) - Install or Replace - For BusinessDoors (Interior) - Install or Replace+6 more

Serving Dover, OK and surrounding areas

Approved

Free estimates

Emergency services offered

Warranties offered

At GP Cabinets & More, we bring over 20 years of combined experience in custom cabinetry, finish carpentry, trim work, and residential remodeling. We are committed to delivering exceptional craftsmanship, honest communication, and dependable service on every project. Whether it’s custom cabinets, interior trim, built-ins, or home renovations, we take pride in quality workmanship and attention to every detail. We proudly serve homeowners throughout Oklahoma and are willing to travel for the right project. Our mission is to exceed expectations by completing every job with professionalism, integrity, and lasting quality

Custom bed
Custom doors
Custom cabinets
Ceiling to the touch
Glass see through

+3

...
Showing 1-10 of 71
Doors questions, answered by experts

You should generally cut between 1/8-inch and 1 inch when planing a door. If you cut off more than that, you risk damaging the door. Planing too much from the bottom of your door can cause noticeable gaps, so it’s always better to start with as thin of a section as possible and work in thin layers until your door no longer sticks.

You want plenty of room between your pre-hung door and the framing in your wall to allow for shimming to get the door into the perfect position, so aim for about 1 inch on the top and both sides. That means you should make your rough opening about 1 inch taller and 2 inches wider than your pre-hung door. You’ll then use shims to stabilize and level the door before installing it.

Depending on the type of French doors you choose, they may be more expensive than sliding doors. Generally speaking, a single in-swing or out-swing French door will cost less than a sliding door, as it contains fewer materials and is easier to install. However, sliding doors usually have a slightly lower price tag, especially when compared to the standard double in-swing or double out-swing French doors.

Adding a doggie door can allow a burglar access to knobs and locks on your door. If your pet door doesn’t come with an alarm, you can add a weight sensor alarm that will trip if anything heavier than your pet enters through it. Adding a motion sensor light to the room your pet door is in can also help deter burglars.

Outswing doors are more popular for exterior doors as they offer more room for moving items in and out of a home. And because the hinges are on the outside of the door, they’re more secure against potential break-ins. But, outswing doors are more susceptible to the elements and are more expensive. Comparing inswing vs. outswing doors depends on your budget, needs, and overall preference.

The Dover, OK homeowners’ guide to door services

From average costs to expert advice, get all the answers you need to get your job done.