Get matched with top water heater pros in Commerce, OK

Most hot water heater manufacturers recommend replacing the anode rod about once every three to five years. Anode rods sacrifice themselves by collecting iron, limestone, and other minerals that would otherwise corrode your hot water heater tank. This abuse wears them out long before your water heater does. Check the rod when you remove it and replace it if more than 50% of the metal has been consumed. Check the rod more frequently if you have hard water or use a water softener. 

Any item that can hold on to moisture and encourage mold growth should be discarded and replaced following water damage. Upholstered items, such as armchairs and couches, and soft items, such as mattresses, usually must be thrown away once they've taken on a lot of water. Soft furniture is difficult to dry out, creating an inviting environment for mold.

You may also need to replace hardwood furniture following water damage if you're unable to fully dry it out. If you have appliances and electronics that have been fully submerged in water, particularly sewage, you'll need to replace those, too.

Yes, most municipalities have codes that require water heaters to have pans. A pan is necessary when a water heater or hot water storage tank is installed in an area where water leakage could cause damage, such as an attic, second floor, or finished basement. Tankless water heaters are not required to have a pan since there is no storage tank.

Several signs indicate your water heater may be failing or in need of replacement. Key indicators include:

• Age: A water heater older than ten years is approaching the end of its typical lifespan.

• Water Quality: If you notice rusty or discolored water from your hot water faucets, or a foul odor similar to rotten eggs or sulfur, it can signal internal corrosion.

• Unusual Noises: Banging, rumbling, or popping sounds from the tank often mean sediment has built up, causing the unit to overheat.

• Leaks: Any water pooling around the base of the tank or visible leaks are clear signs of failure.

• Performance Issues: A decline in performance, such as water not getting hot enough, taking longer to heat up, low water pressure, or decreased efficiency, suggests the unit is struggling.

• Visible Damage: Obvious rust and corrosion on the exterior of the tank can indicate a more serious internal problem.

While these signs often point to replacement, some issues may be fixable. It's best to consult a professional plumber to diagnose the problem before investing in a new unit.