Get matched with top leather and vinyl repair specialists in Greenwich, OH

Although it isn’t recommended to use more than 1,500 pounds of force per square inch (or PSI) on delicate siding materials like wood and metal, it’s safe to use more than that on surfaces made of stone, cement, and, yes, vinyl. In most cases, you can use up to 3,500 PSI without any problems, though you’ll want to make sure to use a tip with a spray span that better disperses this pressure, like a green or yellow tip.

In general, vinyl flooring resists scratches, dents, and tears, but this can vary from one type of vinyl (and manufacturer) to another. Vinyl flooring has a wear layer that ranges in thickness from 6 to 20 millimeters. This layer offers protection against standard scratches, but vinyl with a thicker wear layer will resist scratches better than those with a thin layer.

If there’s minimal buckling and it was caused by minor moisture damage, the planks may lay flat again once you’ve addressed the underlying issue. However, laminate floors that have experienced significant moisture damage won’t lay flat and must be replaced. If the issue only affects one or two boards, you can replace them yourself relatively easily. However, it’s best to call a pro if the problem is more widespread.

If you have mold under your vinyl flooring, it’s recommended that you have it ripped out and start fresh. Mold isn’t something to take lightly and should involve a visit from a professional who can both test and identify the mold. If you’re determined to remedy it yourself, wear all the proper protective equipment—eye goggles, a high N-rated mask, and long, disposable gloves.