Best pressure washers near Bryan, OH

Yes, you can pressure wash epoxy floors, but you must take precautions to avoid damaging the surface. While most epoxy floors can be cleaned with a mop, you might choose to pressure wash if the floor is stained, has ground-in dirt, or is covered with mold or mildew. To do so safely, first soak any stains or dirty areas with a gentle cleanser. Use a lower pressure setting with a gentle nozzle, such as a green, white, or black tip, or a 45-degree angled tip. Keep the spray nozzle at least 18 inches away from the floor to protect the surface. Using a surface cleaner attachment or a rotary scrubber can also help prevent overspray. Be cautious if using a power washer that heats the water, as the combination of heat and pressure may be too powerful and could damage the epoxy coating.

Hardscaping is made to withstand the elements, but it still needs regular cleaning as well as maintenance like weeding, replacing broken pieces, removing mold or mildew, and more. Use an appropriate cleaner for the hardscaping material with a stiff brush to remove dirt and other material, or use a pressure washer for a deep clean. Staying on top of maintenance can alert you to any problems with your hardscaping that will need repair or replacement.

It may be necessary to power wash your house, depending on the siding material. Vinyl, composite, or metal siding can hold up to the heat and pressure of occasional power washing, but materials like brick, stucco, wood, and painted materials may get damaged from the high-pressure water. For sensitive materials, consider a soft wash instead of a pressure wash.

You should wait until your pavers have completely dried and cured before pressure washing them. Wait at least three to five days, though some sealants may need up to an entire week. Rushing that timeline can mess with the finish, weaken the seal, or leave streaks that are tough to fix. Once the sealant has fully set, stick to a gentle approach. Keep the pressure under 1,500 PSI and hold the nozzle at least two feet from the surface. Anything stronger or closer can blast the joint sand loose or wear down the sealant you just applied.