Top-rated carpenters.

Get matched with top carpenters in Fallsburg, NY

Enter your zip and get matched with up to 5 pros

Need a pro for your carpentry project in Fallsburg, NY?

Select your specific project to find the pro for you.

Find Carpenters in Fallsburg

Avatar for Prime Construction
Prime Construction
4.6(
33
)
Deck or Porch - Repair

Serving Fallsburg, NY and surrounding areas

Approved

Super Service Award Winner

In business since 2023

Free estimates

Emergency services offered

"Mike and his crew just finished siding my house. The work was done impeccably and in the time line promised. We are getting ready to do some Bigger projects and can’t wait for them to start. Prime construction was the perfect choice for me! Thanks, Mike. Get ready!"
Rock hill
Rock hill
Deck job
Decks & Porches Project
Remodeling general construction

+139

Response time2 days
Response rate93%
Recommended by48%of homeowners
Avatar for Sullivan Tile and Home Improvement, LLC
Sullivan Tile and Home Improvement, LLC
4.9(
18
)
Interior Trim and Decorative Moldings - Repair

Serving Fallsburg, NY and surrounding areas

Approved

In business since 2019

Free estimates

Warranties offered

"I hired him to lay down a,tile floor andxre sheet rock and paint my down stairs bathroom. He was very good at doing hone repairs . He was very clean in his,work. I would recommend him to everyone I could."
Shower subway tile with accent in the corner
kitchen floor
kitchen backsplash
Tub Surround
bath floor

+35

Response time1 day
Response rate99%
9 neighbors recently requested a quote
Avatar for M.L. Plumbing
M.L. Plumbing
5.0(
4
)
Deck or Porch - Repair

Serving Fallsburg, NY and surrounding areas

Approved

Free estimates

Credit card accepted

"Had a gas leak in my mechanical room next to my boiler and hot water heater and M.L plumbing came and tested the lines and found the leak and fixed the leaking pipe.Thanks M.L plumbing for job well done and at a very reasonable price👍."
Grady's Painting Plastering/Construction
2.0(
174
)
Exterior Shutters - Repair or RestoreWindow Frame - Repair

Serving Fallsburg, NY and surrounding areas

Approved

In business since 1969

Free estimates

Emergency services offered

"I needed stucco repair work on an old chimney (and other spots). Grady was meticulous and thoughtful on what approaches and materials would work. Throughout the project they allocated sufficient time for each treatment to cure and inspected the work before proceeding to the next step. Grady started the project with no money down and only required ongoing payments for materials until the project was well underway. The final payment was due only after they did a final inspection. Total project cost was also below other bids."
Response time11 hrs
Response rate100%
Recommended by57%of homeowners
...
Showing 1-10 of 180
Carpentry questions, answered by experts

It’s best to use two screws to secure deck boards into every joist. Securing the boards to every joist makes the deck more structurally sound, while using two screws on the outer sides of the boards can help prevent warping and cupping.

You may need a permit to install your window seat. Even though it's an indoor modification, some municipalities require permits for any built-ins added to homes. Check with your carpenter or, if you're DIY-ing, do some research on your city's requirements.

You can enclose an open carport, however, there are several things to consider before opting to do so. You'll want to check local building codes and permit requirements before proceeding to make sure it’s legal. While you can sometimes stick-frame a carport enclosure, pre-fab kits are also available. Remember that you'll likely need to meet concrete slab regulations and provide lighting inside the structure. Both of which could substantially drive up costs.

If you remove a load-bearing wall to create an entrance to a carport or covered patio, you can expect to pay between $3,200 and $9,500, with an average cost of $6,400. Factors such as the type of addition and if that area needs additional work will add to the price.

Installing a tongue-and-groove wall requires similar techniques to those associated with installing shiplap. However, because of the precision necessary to make each board fit perfectly and the increased material prices, the cost is higher than that of shiplap installations. Expect to spend between $2 and $6 more per square foot for tongue-and-groove walls versus shiplap ones.

The Fallsburg, NY homeowners’ guide to carpentry services

From average costs to expert advice, get all the answers you need to get your job done.