Get matched with top epoxy flooring pros in Mcgill, NV

Spills like water, oil, or grease can wear down the epoxy's strength, lowering its lifespan. While this damage doesn’t happen immediately, it can accumulate over time, so cleaning up any garage spills as soon as they happen is essential. Avoid cleaning with or using dish soap on your epoxy floors since they will leave an unattractive residue. Instead, you can use half of a cup of ammonia diluted with a gallon of water for cleaning purposes.

Yes, you can seal old or existing concrete, but proper preparation is crucial. The concrete surface must be clean, dry, and free of any incompatible old sealant. To check if an old sealer is present, drip a few drops of water onto the surface; if the water is absorbed in under five minutes, it's ready to be resealed. If you plan to use the same type of sealer that was previously applied, you may not need to remove the old layer. However, if you are using a different type of sealer, the old one must be completely removed. Before applying the new sealer, thoroughly clean the concrete and repair or fill any cracks to ensure a smooth, well-prepared surface.

Ensures durability and even application, enhancing both appearance and longevity.

Most concrete sealers take about one to three hours to dry. However, those that penetrate may take up to 48 hours or more to completely dry. You can find specific drying details from the manufacturer on the label.