Get matched with top sump pump installation pros in Ely, NV

"Of five quotes requested, only 3 replied. Randy was the first and replied promptly. Surprisingly he could fix the problem the same day! His appointment was for 5pm, at 5:01 Randy texted he was running a little late. Wonderful customer service. My repairs were made quickly and for a fair and reasonable price. I'd definitely recommend Handy Randy, and plan to use him for a couple of other projects."

"Great! The technician helped us to locate the issue and explained how to fix it ourselves. This was my 3rd time using NeliHome. They are my first go to for diagnosing an appliance issue."

"Great. Only once did we have to get them back and that was when a leak occurred under bathroom sink not connected to work that had just been completed. Came back within hours. We just shut off water under sink and waited a bit. Can't give a date as to last service but it was about Sept. or Oct of 2020. However, heat pump installed about 10 years ago or more. Would have to dig in files to determine exact dates."

"We bought the place knowing the water pipes needed to be replaced and it was the first task we took on after closing. D&D were good to work with. They were on time, had to track where the water lines were, cut out minimal drywall to do so, and worked with us to relocate the heater indoors from the crawl space, add water overflow pan/drain and were flexible regarding how to run the lines for an expected new washer/dryer. The whole job took two days to complete, with us taking care of drywall repairs later. We had one small and very slow drip leak involving one Rehau connector to the water heater which they fixed with a new Pex constriction ring. We have near instant hot water in the master bath now, very quick elsewhere; lower bills and greater confidence in the water pipes. The also fixed the main sewer line which was hanging low due to broken nylon hanging bands using a better strap system and J-hook at a 90 degree elbow at a corner. Our water pressure was well over 80 PSI with no regulator to begin with and the addition of a regulator was welcome relief to the potential effects. They replaced the "home made" home-run system made with individual T connectors on both hot and cold sides with a standard layout that is efficient for our small place. They included new hose bibs with frost protection brass fittings. The only concern we had was a pipe crossing in the primary wet wall between the utility room and master bath caused us to have to trim out the studs for drywall to fit well afterwards. We brought this to their attention and know they took some action to address it, but turned out not to be enough to satisfy the drywall; shimming the drywall out worked well enough, just a little more time. All in all, we were very satisfied with the effort and thought it well worth the price to get rid of the risk with polybutylene pipes and getting the water heater in a better environment.."