Get matched with top sink repair pros in Serafina, NM

A handyperson with basic plumbing experience can install a bathroom faucet, like the kind of skills you’d need to replace a P-trap or swap out a showerhead. They may not have deep knowledge of local plumbing code, though. If your faucet installation requires work on the pipes behind the wall or under the floor, hire a licensed plumber with the necessary training and licensing. 

Older faucet fixtures may have some corrosion, leaving them stuck. Try a few techniques to loosen the fixtures.

• Wrap the fixture with a towel and tap the base with a hammer.

• Use a putty knife to gently remove any caulk that may be holding the handle or fixture in place.

• Apply a few drops of penetrating oil around the base of the fixture or around the nuts.

• Purchase a faucet pulling tool to pop the fixture loose.

Yes, a toilet, sink, and shower can share the same vent. This is a common plumbing practice that can simplify installation and save space. When sharing a vent, it's important that the toilet is located downstream from all other fixtures. You will also need to ensure the vent pipe is large enough to handle the demands of all connected fixtures without compromising its effectiveness. Because requirements can vary, you should always check your local building and plumbing codes. Consulting a qualified plumber is recommended to ensure the vent is properly sized, installed, and adheres to all local regulations.

While the drain connection for a garbage disposal is nearly universal and fits standard sink drain holes of 3 1/2 to 4 inches, the size of the disposal unit itself is not. You must have enough space in the cabinet underneath your sink to accommodate the disposal's housing. A larger model may not fit in a compact cabinet or if the existing plumbing is arranged in an unusual way. Before buying a new garbage disposal, measure the available space under your sink. If you are replacing an old unit, it's often easiest to choose a new model of a similar size.